Search research articles

ABOUT JoVE

Overview Leadership Blog JoVE Help Center

AUTHORS

Publishing Process Editorial Board Scope & Policies Peer Review FAQ Submit

LIBRARIANS

Testimonials Subscriptions Access Resources Library Advisory Board FAQ

RESEARCH

JoVE Journal Methods Collections JoVE Encyclopedia of Experiments Archive

EDUCATION

JoVE Core JoVE Business JoVE Science Education JoVE Lab Manual Faculty Resource Center Faculty Site

Terms & Conditions of Use

Related Concept Videos

Gain

Gain

Gain and phase shift are properties of linear circuits that describe the effect a circuit has on a sinusoidal input voltage or current. The circuit's behavior that contains reactive elements will depend on the frequency of the input sinusoid. As a result, it is observed that the gain and phase shift will all be frequency functions.
Gain:
Suppose Vin is the input and Vout is the output signal to a circuit.

Small-Signal Analysis of MOSFET Amplifiers

Small-Signal Analysis of MOSFET Amplifiers

In small-signal analysis, a MOSFET transistor amplifier acts as a linear amplifier when operating in its saturation region. The gate-to-source voltage (VGS) of the MOSFET is the sum of the DC biasing voltage and the small time-varying input signal. This combination sets up the operating point and modulates the drain current (ID) that flows from the drain to the source. When a small AC signal is superimposed on the DC bias voltage at the gate, the instantaneous drain current comprises three...

Small-Signal Analysis of BJT Amplifiers

Small-Signal Analysis of BJT Amplifiers

Small signal analysis is a fundamental approach used in electronics to understand how a Bipolar Junction Transistor (BJT) amplifier processes signals. In the active region, the BJT is designed for linear amplification. The transistor's behavior under these conditions is governed by its instantaneous base-emitter voltage VBE, a sum of the DC bias VBE, and a small AC signal VBE, resulting in the collector current iC. Here, the collector current has a DC component and an AC component.

MOSFET Amplifiers

MOSFET Amplifiers

The MOSFET, when operating in its active region, functions as a voltage-controlled current source. In this region, the gate-to-source voltage controls the drain current. This principle underlies the operation of the transconductance MOSFET amplifier. The output current is directed through a load resistor to convert this amplifier into a voltage amplifier. The output voltage is then obtained by subtracting the voltage drop across the load resistance from the supply voltage. This process results...

Instrumentation Amplifier

Instrumentation Amplifier

An electrocardiography (ECG) machine is an essential piece of medical equipment used to monitor the electrical activity of the heart. It operates by detecting small electrical changes on the skin that result from the depolarization of the heart muscle during each heartbeat. However, these signals are in the microvolt range and can be easily overwhelmed by noise or interference.
To overcome this challenge, an ECG machine utilizes an instrumentation amplifier. This specialized amplifier is...

BJT Amplifiers

BJT Amplifiers

Bipolar Junction Transistors (BJTs) are pivotal components in amplifier circuits, functioning as voltage-controlled current sources in their active region. This characteristic allows them to efficiently control the collector current through variations in the base-emitter voltage. Essentially, BJTs amplify power due to their ability to take a weak input signal and output a much stronger signal.
In BJT amplifier configurations, particularly in common-emitter setups, the transistor's role extends...

You might also read

Related Articles

Articles linked to this work by shared authors, journal, and citation graph.

Sort by

Same author

Measurement of distributed losses in optical waveguides: a new technique.

Applied optics·2010

Same author

Dynamics of mode-locked laser diodes employing a repetitive short pulse drive current.

Applied optics·2010

Same author

Low-loss GeO(2) optical waveguide fabrication using low deposition rate rf sputtering.

Applied optics·2010

Same author

Regenerative diode laser pulser.

Applied optics·2010

Same author

Characterization of single-mode optical fiber filters.

Applied optics·2010

Same author

Sensitivity limits of a tunable diode laser spectrometer, with application to the detection of NO(2) at the 100-ppt level.

Applied optics·2010

Search research articles

Related Experiment Video

Updated: Jun 15, 2026

Gain-compensation Methodology for a Sinusoidal Scan of a Galvanometer Mirror in Proportional-Integral-Differential Control Using Pre-emphasis Techniques

Gain-compensation Methodology for a Sinusoidal Scan of a Galvanometer Mirror in Proportional-Integral-Differential Control Using Pre-emphasis Techniques

Published on: April 4, 2017

Novel gain measurement technique for high gain amplifiers.

B K Garside, T Efthymiopoulos

|March 10, 2010

Summary

A novel method simplifies gain determination in high gain amplifiers by analyzing amplified spontaneous emission. This technique offers accurate gain measurements using relative intensity and spectral width data.

Area of Science:

Optics and Photonics
Laser Physics
Nonlinear Optics

Background:

Accurate gain determination is crucial for optimizing high gain amplifier performance.
Existing methods for gain measurement can be complex or limited in scope.

Purpose of the Study:

To introduce and validate a new, simplified method for measuring gain in high gain amplifiers.
To demonstrate the technique's applicability using a specific experimental setup.

Main Methods:

Measuring relative intensity and output spectral width of amplified spontaneous emission.
Varying input pumping levels to observe changes in emission characteristics.
Employing simple analytical models to interpret experimental data and calculate gain.

More Related Videos

Measurement of Scattering Nonlinearities from a Single Plasmonic Nanoparticle

Measurement of Scattering Nonlinearities from a Single Plasmonic Nanoparticle

Published on: January 3, 2016

Related Experiment Videos

Last Updated: Jun 15, 2026

Gain-compensation Methodology for a Sinusoidal Scan of a Galvanometer Mirror in Proportional-Integral-Differential Control Using Pre-emphasis Techniques

Gain-compensation Methodology for a Sinusoidal Scan of a Galvanometer Mirror in Proportional-Integral-Differential Control Using Pre-emphasis Techniques

Published on: April 4, 2017

Measurement of Scattering Nonlinearities from a Single Plasmonic Nanoparticle

Measurement of Scattering Nonlinearities from a Single Plasmonic Nanoparticle

Published on: January 3, 2016

Main Results:

The new method accurately determines amplifier gain.
Experimental results using a rhodamine 6G dye amplifier show good agreement with the proposed technique.
The findings align well with more precise gain measurements and an alternative method.

Conclusions:

The reported technique provides a straightforward and effective approach for gain assessment in high gain amplifiers.
This method offers a valuable alternative for characterizing amplifier performance, especially when other techniques are restricted.