Related Experiment Video
Updated: Jun 15, 2026

Collection and Extraction of Occupational Air Samples for Analysis of Fungal DNA
Published on: May 2, 2018
Adsorption efficiency of respirator filter cartridges for isocyanates
Marcus Gustavsson1, Elinor Meiby, Daniel Gylestam
1Work Environment Chemistry, Stockholm University, 281 24 Hässleholm, Sweden.
Abstract:
In some industries, the temperature and the humidity will vary greatly between different work places, such as outdoor work in arctic or tropical climates. There is therefore a need to test respirator filters at conditions that simulate conditions that are relevant for the industries that they are used in. Filter cartridges were exposed to controlled atmospheres of varying isocyanate concentration, air humidity, and temperature in an exposure chamber. For isocyanic acid (ICA) and methyl isocyanate (MIC), the exposure concentrations were between 100 and 200 p.p.b., monitored using a proton transfer reaction mass spectrometer. ICA and MIC were generated by continuous thermal degradation of urea and dimethylurea. The breakthrough was studied by collecting air samples at the outlet of the filter cartridges using impinger flasks or dry samplers with di-n-butylamine as derivatization reagent for isocyanates followed by liquid chromatography tandem mass spectrometry (LC-MS/MS) analysis. For hexamethylene diisocyanate (HDI) and isophorone diisocyanate (IPDI), the exposure concentrations were between 4 and 20 p.p.b. and were generated by wet membrane permeation. To reveal the profile of adsorption in different layers of the respirator filters, representative samples from each of the layers were hydrolyzed. The hydrolysis products hexamethylene diamine and isophorone diamine were determined after derivatization with pentafluoropropionic anhydride (PFPA) followed by LC-MS/MS analysis. The two filter types studied efficiently absorbed both ICA and MIC. There was no trend of impaired performance throughout 48-h exposure tests. Even when the filters were exposed to high concentrations (approximately 200 p.p.b.) of ICA and MIC for 96 h, the isocyanates were efficiently absorbed with only a limited breakthrough. The majority of the HDI and IPDI (>90%) were absorbed in the top layers of the absorbant, but HDI and IPDI penetrated farther down into the respirator filters during 120 h of exposure as compared to 16 h exposure.
More Related Videos
08:00A Synthetic Methodology for Preparing Impregnated and Grafted Amine-Based Silica Composites for Carbon Capture
Published on: September 29, 2023
10:44Preparation of Biomass-based Mesoporous Carbon with Higher Nitrogen-/Oxygen-chelating Adsorption for Cu(II) Through Microwave Pre-Pyrolysis
Published on: February 12, 2019
Related Concept Videos
Adsorption of Gases on Solids
Adsorption Isotherms I
Oxygen Delivering System I: Nasal Cannula and Face Mask
Nasal Cannula
A nasal cannula is a lightweight tube split at one end into two prongs and placed in the nostrils. It is typically used to deliver low to medium levels of oxygen.
Suggested flow rate: The suggested flow rate for a nasal cannula typically ranges between 1 and 6 L/min.
Oxygen percentage setting:...
Adsorption Isotherms II