Related Experiment Video
Updated: Jun 13, 2026

Fabrication of Carbon Nanotube High-Frequency Nanoelectronic Biosensor for Sensing in High Ionic Strength Solutions
Published on: July 22, 2013
Concentration effect of carbon nanotube based saturable absorber on stabilizing and shortening mode-locked pulse
Jin-Chen Chiu1, Yi-Fen Lan, Chia-Ming Chang
1Department of Photonics, National Sun Yat-sen University, Kaohsiung, Taiwan.
Abstract:
We comprehensively investigated the concentration effect of dispersed single-walled carbon nanotubes (SWCNTs) in polymer films for being a saturable absorber (SA) to stabilize the mode locking performance of the erbium-doped fiber laser (EDFL) pulse through the diagnosis of its nonlinear properties of SA. The measured modulation depth was from 1 to 4.5% as the thickness increased 18 to 265 microm. The full-width half-maximum (FWHM) of the stable mode-locked EDFL (MLEDFL) pulse decreased from 3.43 to 2.02 ps as the concentrations of SWCNTs SA increased 0.125 to 0.5 wt%. At constant concentration of 0.125 wt%, the similar pulse shortening effect of the MLEDFL was also observed when the FWHM decreased from 3.43 to 1.85 ps as the thickness of SWCNTs SA increased 8 to 100 microm. With an erbium-doped fiber length of 80 cm, the shortest pulse width of 1.85 ps were achieved at 1.56 microm with a repetition rate of 11.1 MHz and 0.2 mW of the output power under an output coupling ratio of 5%. An in-depth study on the stable mode-locked pulse formation employing SWCNTs SA, it is possible to fabricate the SWCNT films for use in high performance MLEDFL and utilization of many other low-cost nanodevices.
More Related Videos
08:48Low-cost Custom Fabrication and Mode-locked Operation of an All-normal-dispersion Femtosecond Fiber Laser for Multiphoton Microscopy
Published on: November 22, 2019
09:12Functionalization of Single-walled Carbon Nanotubes with Thermo-reversible Block Copolymers and Characterization by Small-angle Neutron Scattering
Published on: June 1, 2016