Related Experiment Video

Updated: Jun 13, 2026

Production of a Strain-Measuring Device with an Improved 3D Printer
06:17

Production of a Strain-Measuring Device with an Improved 3D Printer

Published on: January 30, 2020

Measurement of stresses in optical fiber and preform

P L Chu, T Whitbread

    Applied Optics
    |April 20, 2010
    PubMed

    More Related Videos

    Optimized Sealing Process and Real-Time Monitoring of Glass-to-Metal Seal Structures04:41

    Optimized Sealing Process and Real-Time Monitoring of Glass-to-Metal Seal Structures

    Published on: September 2, 2019

    Measuring the Mechanical Properties of Glass Fiber Reinforcement Polymer Composite Laminates Obtained by Different Fabrication Processes09:54

    Measuring the Mechanical Properties of Glass Fiber Reinforcement Polymer Composite Laminates Obtained by Different Fabrication Processes

    Published on: June 30, 2023

    Related Concept Videos

    Measurements of Strain01:27

    Measurements of Strain

    Strain quantifies the deformation of a material under force, typically measured as normal strain, which represents the change in length when compared with the original length. Electrical strain gauges are used for enhanced accuracy. These devices consist of a conductive wire mounted on a paper backing that adheres to the material's surface. These gauges operate on the piezoresistive effect, where the wire's electrical resistance changes in response to mechanical deformation. The strain gauge...
    Stress Concentrations01:24

    Stress Concentrations

    Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller width...
    Stress Concentrations01:13

    Stress Concentrations

    The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
    The stress concentration...
    Principal Stresses in a Beam01:11

    Principal Stresses in a Beam

    In prismatic beams subject to arbitrary transverse loading, It is essential to analyze the interaction between shear forces and bending moments in order to understand stress distribution and ensure structural integrity. The highest normal or bending stress occurs at the outer fibers of the beam, decreasing linearly to zero at the neutral axis. In contrast, shear stress peaks at the neutral axis and diminishes toward the outer surfaces.
    Analyzing principal stresses is crucial, especially in...
    Strain and Elastic Modulus01:15

    Strain and Elastic Modulus

    The quantity that describes the deformation of a body under stress is known as strain. Strain is given as a fractional change in either length, volume, or geometry under tensile, volume (also known as bulk), or shear stress, respectively, and is a dimensionless quantity. The strain experienced by a body under tensile or compressive stress is called tensile or compressive strain, respectively. In contrast, the strain experienced under bulk stress and shear stress is known as volume and shear...
    Stresses under Combined Loadings01:23

    Stresses under Combined Loadings

    When analyzing a bent tube with a circular cross-section subjected to multiple forces, it is crucial to determine the stress distribution in order to maintain structural integrity under varied load conditions.
    The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...