Related Experiment Video
Updated: Jun 13, 2026
An in vivo Assay to Test Blood Vessel Permeability
Published on: March 16, 2013
In situ artificial membrane permeation assay under hydrodynamic control: permeability-pH profiles of warfarin and
Matej Velický1, Dan F Bradley, Kin Y Tam
1School of Chemistry, University of Manchester, Oxford Road, Manchester, M13 9PL, UK.
Purpose:
To investigate the permeation of two ionisable drug molecules, warfarin and verapamil, across artificial membranes. For the first time since the introduction of the parallel artificial membrane permeation assay (PAMPA) in 1998, in situ permeation-time profiles of drug molecules are studied.
Methods:
The method employs a rotating-diffusion cell where the donor and acceptor compartments are separated by a lipid-impregnated artificial membrane. The permeation of the solute is investigated under well-defined hydrodynamic conditions with control over the unstirred water layer. The flux of the permeating molecule is analysed in situ using UV spectrophotometry.
Results:
In situ permeation-time profiles are obtained under hydrodynamic control and used to determine permeability coefficients. An advanced analytical transport model is derived to account for the membrane retention, two-way flux and pH gradient between the two compartments. Moreover, a numerical permeation model was developed to rationalise the time-dependent permeation profiles. The membrane permeability, intrinsic permeability and unstirred water permeability coefficients of two drug molecules are obtained from two independent methods, hydrodynamic extrapolation and pH profiling, and the results are compared.
Conclusions:
Both warfarin and verapamil exhibit high permeability values, which is consistent with the high fraction absorbed in human. Our results demonstrate that a considerable lag-time, varying with the solute lipophilicity and stirring rate, exists in membrane permeation and leads to incorrect compound ranking if it is not treated properly. Comparison of the permeability data as a function of pH and stirring rate suggests that some transport of the ionized molecules occurs, most likely via ion-pairing.
Related Concept Videos
01:16Methods for Studying Drug Absorption: In vitro
The diffusion cell method uses a two-compartment cell, including a donor compartment with the drug solution, which simulates the environment where the drug is applied, and a receptor compartment with a buffer solution, which simulates the environment...
01:09Methods for Studying Drug Absorption: In situ
The Doluisio method involves perfusing a prepared segment of a rat's small intestine with a solution of radiolabeled drug and a non-absorbable marker. This helps to differentiate between absorbed and non-absorbed drug concentrations. The intestinal segment is connected at both ends using tubing and syringes,...
01:25Physiological Barriers
The blood endothelial barrier is the most porous of these. It allows all small ionized, un-ionized, and lipophilic molecules to pass through the endothelial lining into the interstitial space...
01:24Cellular Membranes and Drug Transport
Phospholipids arrange themselves into a bilayer, with hydrophilic heads oriented outward and hydrophobic tails facing inward.
01:23Drug Absorption Mechanism: Passive Membrane Transport
01:17Pore Transport and Ion-Pair Transport
Pore transport, also known as convective transport, is a process where small molecules like urea, water, and sugars rapidly cross cell membranes as though there were channels or pores in the membrane. Although direct microscopic evidence is limited but the concept of pores or channels is widely accepted based on physiological evidence. Despite the lack of direct microscopic...