Related Experiment Video
Updated: Jun 13, 2026

Substantiating Appropriate Motion Capture Techniques for the Assessment of Nordic Walking Gait and Posture in Older Adults
Published on: May 12, 2016
Poling force analysis in diagonal stride at different grades in cross country skiers
B Pellegrini1, L Bortolan, F Schena
1Center of Bioengineering and Sport Science, Faculty of Exercise and Sport Science, University of Verona, Rovereto (TN), Italy. barbara.pellegrini@unitn.it
Abstract:
The aim of this study was to characterize the dynamic parameters of poling action during low to moderate uphill skiing in the diagonal stride technique. Twelve elite cross country skiers performed an incremental test using roller skis on a treadmill at 9 km/h at seven different grades, from 2° to 8°. The pole ground reaction force and the pole inclination were measured, and the propulsive force component and poling power were then calculated. The duration of the active poling phase remained unchanged, while the recovery time decreased with the increase in the slope. The ratio between propulsive and total poling forces (effectiveness) was approximately 60% and increased with the slope. Multiple regression estimated that approximately 80% of the variation of the poling power across slopes was explained by the increase of the poling force, the residual variation was explained by the decrease of the pole inclination, while a small contribution was provided by the increase of the poling relative to the cycle time. The higher power output required to ski at a steeper slope was partially supplied by a greater contribution of the power generated through the pole that arises not only by an increase of the force exerted but also by an increase of its effectiveness.
More Related Videos
06:35Using Gold-standard Gait Analysis Methods to Assess Experience Effects on Lower-limb Mechanics During Moderate High-heeled Jogging and Running
Published on: September 14, 2017
07:19Comparison of Kinetic Characteristics of Footwork during Stroke in Table Tennis: Cross-Step and Chasse Step
Published on: June 16, 2021
Related Concept Videos
Work Done Over an Inclined Plane
The work done by gravity to move a rigid body, or the work done by an opposing force to move a rigid body against gravity, can be calculated using the center-of-mass framework. It is the line integral of the force of gravity over the path, considered positive if...
Two-Dimensional Force System: Problem Solving
The first step to solving a two-dimensional force system problem is to draw a free-body diagram of the object under consideration. This diagram helps identify all the external forces acting on the object, including their...
Two-Dimensional Force System
Design Example: Traverse Angle Computations
Energy Diagrams - II
The point in the energy diagram at which the system’s potential energy is the lowest is known as the local minima. The system tends to stay in this position indefinitely unless acted upon by a net force. The slope of the potential energy diagram at the local minima is zero, indicating that zero net force is acting on the system. The slope...
Three-Dimensional Force System:Problem Solving
To solve a three-dimensional force system, first resolve each force into its respective scalar components. Do this using...