Related Experiment Video
Updated: Jun 11, 2026

Nanotopology of Cell Adhesion upon Variable-Angle Total Internal Reflection Fluorescence Microscopy (VA-TIRFM)
Published on: October 2, 2012
Influence of boundary conditions on photon diffusion through an interface between two turbid media with different
1Photonic Processes Department, Institute of Physics, 46 Prospect Nauki, Kiev 03028, Ukraine. shend@iop.kiev.ua
Abstract:
The photon migration in two semi-infinite highly scattering media with different refractive indices is studied in the diffusion approximation for two sets of boundary conditions at the interface. In commonly used boundary conditions, the ratio of the intensity (fluence rate) to the squared refractive index is assumed continuous across an interface and the normal component of flux is required to be continuous. However, a more rigorous approach shows that the boundary condition for the intensity may be different. As was shown by Aronson [J. Opt. Soc. Am. A12, 2532 (1995)], the ratio of the intensity to the squared refractive index undergoes a jump across an interface that is proportional to the diffuse flux. A diffusion model with an instantaneous point source that can be solved analytically for both sets of boundary conditions is considered. The analytical solutions are derived and compared with the results of Monte Carlo simulations that take into account the reflections and refractions at the interface according to Fresnel's formulas. It is shown that the analytical solutions with the Aronson boundary condition for intensity match the Monte Carlo results better than the solutions with a continuous ratio of the intensity to the squared refractive index.
More Related Videos
Related Concept Videos
Magnetostatic Boundary Conditions
Boundary Conditions for Current Density
Electrostatic Boundary Conditions in Dielectrics
Consider a case where both the mediums across a boundary are two different dielectric materials. Recall that the electric field and electric displacement are proportional and related through the material's permittivity.
Interference and Diffraction
Boundary Conditions: Lossless Lines
At the receiving end, the boundary condition states that the voltage equals the product of the receiving-end impedance and current. This relationship is expressed as a function of the incident and...
Electrostatic Boundary Conditions
The surface integral of an electric field is given by Gauss's law in integral form and is related to...

