Related Experiment Video

Updated: Jun 10, 2026

Characterization of Anisotropic Leaky Mode Modulators for Holovideo
09:36

Characterization of Anisotropic Leaky Mode Modulators for Holovideo

Published on: March 19, 2016

Surface classification by an optoelectronic implementation of the Karhunen-Loève expansion

C Gorecki

    Applied Optics
    |August 19, 2010
    PubMed

    More Related Videos

    Universal Molecular Retention with 11-Fold Expansion Microscopy10:31

    Universal Molecular Retention with 11-Fold Expansion Microscopy

    Published on: October 6, 2023

    A Guide to Structured Illumination TIRF Microscopy at High Speed with Multiple Colors11:15

    A Guide to Structured Illumination TIRF Microscopy at High Speed with Multiple Colors

    Published on: May 30, 2016

    Related Concept Videos

    Classification of Signals01:30

    Classification of Signals

    In signal processing, signals are classified based on various characteristics: continuous-time versus discrete-time, periodic versus aperiodic, analog versus digital, and causal versus noncausal. Each category highlights distinct properties crucial for understanding and manipulating signals.
    A continuous-time signal holds a value at every instant in time, representing information seamlessly. In contrast, a discrete-time signal holds values only at specific moments, often denoted as x(n), where...
    Classification of Systems-II01:31

    Classification of Systems-II

    Continuous-time systems have continuous input and output signals, with time measured continuously. These systems are generally defined by differential or algebraic equations. For instance, in an RC circuit, the relationship between input and output voltage is expressed through a differential equation derived from Ohm's law and the capacitor relation,
    Classification of Systems-I01:26

    Classification of Systems-I

    Linearity is a system property characterized by a direct input-output relationship, combining homogeneity and additivity.
    Homogeneity dictates that if an input x(t) is multiplied by a constant c, the output y(t) is multiplied by the same constant. Mathematically, this is expressed as:
    Convolution: Math, Graphics, and Discrete Signals01:24

    Convolution: Math, Graphics, and Discrete Signals

    In any LTI (Linear Time-Invariant) system, the convolution of two signals is denoted using a convolution operator, assuming all initial conditions are zero. The convolution integral can be divided into two parts: the zero-input or natural response and the zero-state or forced response, with t0 indicating the initial time.
    To simplify the convolution integral, it is assumed that both the input signal and impulse response are zero for negative time values. The graphical convolution process...
    Application of Linearization and Approximation01:29

    Application of Linearization and Approximation

    A drone flying through complex terrain often relies on more than one sensing method to estimate small changes in altitude. Along with direct measurements, air pressure provides a useful indirect indicator of vertical movement. Atmospheric pressure decreases as altitude increases, and this relationship is commonly described using an exponential model. Although accurate, converting pressure measurements into altitude values requires calculations that are too complex to perform repeatedly during...
    Routh-Hurwitz Criterion II01:19

    Routh-Hurwitz Criterion II

    In the application of the Routh-Hurwitz criterion, two specific scenarios can arise that complicate stability analysis.
    The first scenario occurs when a singular zero appears in the first column of the Routh table. This situation creates a division by zero issues. To resolve this, a small positive or negative number, denoted as epsilon (∈), is substituted for the zero. The stability analysis proceeds by assuming a sign for ∈. If ∈ is positive, any sign change in the first column of the Routh...