Thermodynamic aspects of solubility process of some sulfonamides

Solution, Solubility, and Solubility Equilibrium
A solution is a homogeneous mixture composed of a solvent, the major component, and a solute, the minor component. The physical state of a solution—solid, liquid, or gas—is typically the same as that of the solvent. Solute concentrations are often described with qualitative terms such as dilute (of relatively low concentration) and concentrated (of relatively high concentration).
In a solution, the solute particles (molecules, atoms, and/or ions)...

When a substance such as sodium chloride is added to water, it dissolves, forming an aqueous solution. The extent of dissolution is called solubility. The process of dissolution can exist in equilibrium, just like other chemical processes. Solubility equilibria are also called precipitation equilibria because the process of solubility can be reversible. The reverse of the solubility process is called precipitation.
Solubility is important in biological and environmental processes. A notable...

Compared with pure water, the solubility of an ionic compound is less in aqueous solutions containing a common ion (one also produced by dissolution of the ionic compound). This is an example of a phenomenon known as the common ion effect, which is a consequence of the law of mass action that may be explained using Le Chȃtelier’s principle. Consider the dissolution of silver iodide:

Solubility is the measure of the maximum amount of solute that can be dissolved in a given quantity of solvent at a given temperature and pressure. Solubility is usually measured in molarity (M) or moles per liter (mol/L). A compound is termed soluble if it dissolves in water.

The process of a solid dissolving in a liquid to form a solution is governed by the solubility limit, which is the maximum amount of the solid substance, or solute, that can be dissolved in a specific volume of the liquid or solvent. As the solute dissolves, it reaches a point where no more solute can be dissolved at a given temperature - this is known as the saturation point. However, if further solute is added and it manages to dissolve, the solution becomes supersaturated. Supersaturated...

The free energy change associated with dissolving a solute in a liter of solvent is called the free energy of a solution, ΔGsolution. The overall ΔGsolution is expressed as the balance of ΔGinteraction against the always-favorable free-energy of mixing, ΔGmixing. Solution formation is favorable if  ΔGsolution is less than zero, whereas it is unfavorable if ΔGsolution is greater than zero. In short, for a solution to form and complete dissolution to take place, the Gibbs energy change must be...