Related Experiment Video

Updated: Jun 4, 2026

Determination of the Photoisomerization Quantum Yield of a Hydrazone Photoswitch
09:33

Determination of the Photoisomerization Quantum Yield of a Hydrazone Photoswitch

Published on: February 7, 2022

Photochemical control of dielectric properties based on intermolecular proton transfer in a hydrogen-bonded

Masakazu Morimoto1, Masahiro Irie

  • 1Department of Chemistry and Research Center for Smart Molecules, Rikkyo University, Nishi-Ikebukuro 3-34-1, Toshima-ku, Tokyo 171-8501, Japan. m-morimoto@rikkyo.ac.jp

Chemical Communications (Cambridge, England)
|March 2, 2011
PubMed

More Related Videos

Novel Techniques for Observing Structural Dynamics of Photoresponsive Liquid Crystals10:35

Novel Techniques for Observing Structural Dynamics of Photoresponsive Liquid Crystals

Published on: May 29, 2018

Isotopic Effect in Double Proton Transfer Process of Porphycene Investigated by Enhanced QM/MM Method05:51

Isotopic Effect in Double Proton Transfer Process of Porphycene Investigated by Enhanced QM/MM Method

Published on: July 19, 2019

Related Concept Videos

Photochemical Electrocyclic Reactions: Stereochemistry01:26

Photochemical Electrocyclic Reactions: Stereochemistry

The absorption of UV–visible light by conjugated systems causes the promotion of an electron from the ground state to the excited state. Consequently, photochemical electrocyclic reactions proceed via the excited-state HOMO rather than the ground-state HOMO. Since the ground- and excited-state HOMOs have different symmetries, the stereochemical outcome of electrocyclic reactions depends on the mode of activation; i.e., thermal or photochemical.
Selection Rules: Photochemical Activation
Electrophilic Addition of HX to 1,3-Butadiene: Thermodynamic vs Kinetic Control01:23

Electrophilic Addition of HX to 1,3-Butadiene: Thermodynamic vs Kinetic Control

The addition of a hydrogen halide to 1,3-butadiene gives a mixture of 1,2- and 1,4-adducts. Since more substituted alkenes are more stable, the 1,4-adduct is expected to be the major product. However, the product distribution is strongly influenced by temperature; low temperature favors the 1,2-adduct, whereas the 1,4-adduct is predominant at high temperature.
[4+2] Cycloaddition of Conjugated Dienes: Diels–Alder Reaction01:16

[4+2] Cycloaddition of Conjugated Dienes: Diels–Alder Reaction

The Diels–Alder reaction is an example of a thermal pericyclic reaction between a conjugated diene and an alkene or alkyne, commonly referred to as a dienophile. The reaction involves a concerted movement of six π electrons, four from the diene and two from the dienophile, forming an unsaturated six-membered ring. As a result, these reactions are classified as [4+2] cycloadditions.
Stability of Conjugated Dienes01:28

Stability of Conjugated Dienes

Introduction
A comparison of the enthalpies of hydrogenation of dienes reveals that conjugated dienes release less heat on hydrogenation, rendering them more stable than their nonconjugated analogs.
Diels–Alder Reaction Forming Cyclic Products: Stereochemistry01:28

Diels–Alder Reaction Forming Cyclic Products: Stereochemistry

The Diels–Alder reaction is one of the robust methods for synthesizing unsaturated six-membered rings. The reaction involves a concerted cyclic movement of six π electrons: four π electrons from the diene and two π electrons from the dienophile.
Thermal Electrocyclic Reactions: Stereochemistry01:17

Thermal Electrocyclic Reactions: Stereochemistry

The stereochemistry of electrocyclic reactions is strongly influenced by the orbital symmetry of the polyene HOMO. Under thermal conditions, the reaction proceeds via the ground-state HOMO.
Selection Rules: Thermal Activation
Conjugated systems containing an even number of π-electron pairs undergo a conrotatory ring closure. For example, thermal electrocyclization of (2E,4E)-2,4-hexadiene, a conjugated diene containing two π-electron pairs, gives trans-3,4-dimethylcyclobutene.