Fabrication of hemispherical nano structure on a curved Al surface using low-temperature and high-voltage anodizing...

A simple method of fabricating hemispherical nanostructures on a curved aluminum rod surface was presented. In conventional methods of fabricating nanopatterns on a curved aluminum surface, mechanical or chemical processes have been widely used for the lens technologies. Such processes are not only expensive with long processing times, however, but they also involve local fabrication and are limited in the dimension size. In this paper, a method of fabricating hemispherical nanostructures on a curved aluminum surface is suggested for a functional three-dimensional (3D) master using a low-temperature and high-voltage (LTHV) anodizing method. By reducing the aluminum reaction rate under a low-temperature environment, the reaction current density can be remarkably reduced even though a high voltage was induced. Using the LTHV anodizing method, the hemispherical pattern size can be easily controlled with respect to voltage variations. The sizes of the hemispherical nanopatterns were about 150-300 nm. Using the LTHV anodizing process, hemispherical nanostructures can be obtained on a curved aluminum surface with controllable pattern sizes of 150-300 nm without defects such as burring from Joule's heat, micro-scratches, and cracks. A curved 3D hemispherical nanostructure may be used as a master in the roll-to-roll process.