He-ThO(1Σ+) interactions at low temperatures: elastic and inelastic collisions, transport properties, and complex

T V Tscherbul1, E R Sayfutyarova, A A Buchachenko

  • 1Harvard-MIT Center for Ultracold Atoms, Cambridge, Massachusetts 02138, USA. tshcherb@cfa.harvard.edu

Related Concept Videos

Heat Capacities of an Ideal Gas III01:25

Heat Capacities of an Ideal Gas III

The number of independent ways a gas molecule can move along straight line, rotate, and vibrate is called its degrees of freedom. Supposing d represents the number of degrees of freedom of an ideal gas, the molar heat capacity at constant volume of an ideal gas in terms of d is
Hess's Law03:40

Hess's Law

There are two ways to determine the amount of heat involved in a chemical change: measure it experimentally, or calculate it from other experimentally determined enthalpy changes. Some reactions are difficult, if not impossible, to investigate and make accurate measurements for experimentally. And even when a reaction is not hard to perform or measure, it is convenient to be able to determine the heat involved in a reaction without having to perform an experiment.
Joule-Thomson Effect01:21

Joule-Thomson Effect

The Joule-Thomson effect, also known as the Joule-Kelvin effect, describes the temperature change of a fluid when it is forced through a valve or porous plug while keeping it in a thermally insulated environment. This experiment is called a throttling process. This is an important effect widely used in refrigeration and the liquefaction of gases.
This experiment forces high-pressure gas through a throttle valve or a porous plug to a lower-pressure region. The gas expands as it passes through to...
Enthalpies of Physical Changes01:22

Enthalpies of Physical Changes

In thermodynamics, the enthalpy of a system reflects the amount of energy contained within it, which can be used to perform work. When we discuss physical changes in a substance, such as a phase transition from solid to liquid or liquid to gas, we often refer to the concept of enthalpy change.The standard enthalpy changes for a reaction or a physical process are defined as the difference in enthalpy between the products in their standard states and the reactants in their standard states, all...
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
Intermolecular Forces and Physical Properties02:56

Intermolecular Forces and Physical Properties