Related Experiment Video
Updated: Jun 2, 2026

The Frequency Domain Thermoreflectance Technique for Thermal Property Measurements
Published on: December 5, 2025
The thermal index: its strengths, weaknesses, and proposed improvements
Timothy A Bigelow1, Charles C Church, Kurt Sandstrom
1Department of Electrical and Computer Engineering, Iowa State University, 2215 Coover Hall, Ames, IA 50011, USA. bigelow@iastate.edu
Abstract:
The thermal index (TI) has been used as a relative indicator of thermal risk during diagnostic ultrasound examinations for many years. It is useful in providing feedback to the clinician or sonographer, allowing assessment of relative, potential risks to the patient of an adverse effect due to a thermal mechanism. Recently, several shortcomings of the TI formulations in quantifying the risk to the patient have been identified by members of the basic scientific community, and possible improvements to address these shortcomings have been proposed. For this reason, the Output Standards Subcommittee of the American Institute of Ultrasound in Medicine convened a subcommittee to review the strengths of the TI formulations as well as their weaknesses and proposed improvements. This article summarizes the findings of this subcommittee. After a careful review of the literature and an assessment of the cost of updating the TI formulations while maximizing the quality of patient care, the Output Standards Subcommittee makes the following recommendations: (1) some inconsistencies in the current TI formulations should be resolved, and the break point distance should be redefined to take focusing into consideration; (2) an entirely new indicator of thermal risk that incorporates the time dependence not be implemented at this time but be included in continuing efforts toward standards or consensus documents; (3) the exponential dependence of risk on temperature not be incorporated into a new definition of the TI formulations at this time but be included in continuing efforts toward standards or consensus documents; (4) the TI formulations not be altered to include nonlinear propagation at this time but be included in continuing efforts toward standards or consensus documents; and (5) a new indicator for risk from thermal mechanisms should be developed, distinct from the traditional TI formulations, for new imaging modalities such as acoustic radiation force impulse imaging, which have more complicated pulsing sequences than traditional imaging.
Related Concept Videos
Quantifying Heat
Thermodynamic Potentials
Thermal expansion and Thermal stress: Problem Solving
To solve the problem, first, identify the known and unknown quantities. The initial length (L) of the bridge is 1275 m, the coefficient of linear expansion (α) for steel is 12 x 10-6/°C, and the change in temperature (ΔT) is 55 °C.
Joule-Thomson Effect
This experiment forces high-pressure gas through a throttle valve or a porous plug to a lower-pressure region. The gas expands as it passes through to...
Thermal Sigmatropic Reactions: Overview
Sigmatropic shifts are classified based on an order term [i, j ], where i and j indicate the number of atoms across which each end of the σ bond migrates. Below are examples of a [3,3] sigmatropic shift in 1,5-hexadiene, referred to as...
Thermal Strain
