The feasibility of endorectal MR elastography for prostate cancer localization

The objectives of this study were to evaluate the feasibility of using a rigid radio-frequency receiver endorectal coil for intracavitary prostate magnetic resonance elastography (MRE) and to demonstrate the capability of this technique for generating stiffness maps over a typical prostate volume. An endorectal coil is currently used to help improve the signal-to-noise ratio of images acquired with multiparametric magnetic resonance imaging. We propose that this same coil could also serve to generate shear waves in the prostate gland during imaging, opening up the possibility of incorporating prostate stiffness characterization into multiparametric magnetic resonance imaging. Prostate cancer has been shown to change the elasticity of tissue, suggesting that stiffness imaging (elastography) may provide supplementary diagnostic information. A rigid endorectal coil was mechanically coupled to a piezoceramic actuator and used to investigate full volume (27 slices, 2-mm thick) endorectal MRE in a prostate mimicking phantom. The low-amplitude vibrations (± 8-38 μm displacements) necessary to perform endorectal MRE did not affect the signal-to noise ratio of the coil and endorectal MRE was capable of resolving 0.1 cc (0.6 cm diameter) spherical inclusion volumes. Therefore, the results of this study, in combination with current clinical practice, motivate clinical evaluation of endorectal MRE in patients.