Glow discharge mass spectrometric analysis of atmospheric particulate matter

A direct current (dc) glow discharge mass spectrometer has been used to analyze atmospheric particulate matter. The sample preparation used is simple and time-saving. The air is sucked by a pump through a single-orifice impactor stage, in which the aerosols are impacted on a metal support, forming a central spot. This metal plate is directly used as a cathode in a dc glow discharge mass spectrometer. Evaluation of the sample loading and of the discharge parameters allowed us to optimize the signal intensity and to minimize its decrease, the latter being a consequence of its consumption by continuous sputtering in the discharge. The available aerosol analysis time could be prolonged to more than 3 h, a time span necessary to perform a multielement analysis using a magnetic sector instrument and long integration times. A NIST reference aerosol was measured to evaluate the quantitative analysis potential. The internal reproducibility was better than 10% RSD, and the limits of detection were estimated to be in the low ppm or sub ppm region. Even without the use of any standards or correction factors, glow discharge mass spectrometry could offer good semiquantitative results, based only on the use of an internal standard.