Related Experiment Video

Updated: May 31, 2026

Fabrication of Schottky Diodes on Zn-polar BeMgZnO/ZnO Heterostructure Grown by Plasma-assisted Molecular Beam Epitaxy
14:16

Fabrication of Schottky Diodes on Zn-polar BeMgZnO/ZnO Heterostructure Grown by Plasma-assisted Molecular Beam Epitaxy

Published on: October 23, 2018

Solid-liquid interfacial energy of the solid Mg(2)Zn(11) phase in equilibrium with Zn-Mg eutectic liquid

M Erol1, K Keşlioğlu, N Maraşli

  • 1Department of Physics, Faculty of Arts and Sciences, Bozok University, 66100 Yozgat, Turkey.

Journal of Physics. Condensed Matter : an Institute of Physics Journal
|June 22, 2011
PubMed

More Related Videos

Plasma-Assisted Molecular Beam Epitaxy Growth of Mg3N2 and Zn3N2 Thin Films13:05

Plasma-Assisted Molecular Beam Epitaxy Growth of Mg3N2 and Zn3N2 Thin Films

Published on: May 11, 2019

Bulk and Thin Film Synthesis of Compositionally Variant Entropy-stabilized Oxides09:41

Bulk and Thin Film Synthesis of Compositionally Variant Entropy-stabilized Oxides

Published on: May 29, 2018

Related Concept Videos

Solid–Solid Solutions01:24

Solid–Solid Solutions

The temperature-composition phase diagram of two solids, A and B, which are immiscible in the solid phase but form miscible liquids, shows that when the temperature is low, these two exist as separate, pure solids (A and B). As the temperature increases, they transition into a single-phase liquid solution where A and B coexist. Moving from point a1 to a2 in the phase diagram, the composition changes such that solid B begins to separate from the solution, enriching the remaining liquid with A.
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
Phase Transitions: Sublimation and Deposition02:33

Phase Transitions: Sublimation and Deposition

Some solids can transition directly into the gaseous state, bypassing the liquid state, via a process known as sublimation. At room temperature and standard pressure, a piece of dry ice (solid CO2) sublimes, appearing to gradually disappear without ever forming any liquid. Snow and ice sublimate at temperatures below the melting point of water, a slow process that may be accelerated by winds and the reduced atmospheric pressures at high altitudes. When solid iodine is warmed, the solid sublimes...
Lattice Energies of Ionic Crystals01:27

Lattice Energies of Ionic Crystals

Lattice energy represents the energy released when gaseous cations and anions combine to form an ionic solid, reflecting the strength of electrostatic interactions within the crystal. This process is fundamentally governed by Coulombic attraction between oppositely charged ions, where the potential energy varies inversely with the interionic distance and directly with the product of ionic charges. As ions approach one another, the electrostatic energy becomes increasingly negative, indicating a...
Liquid–Solid Solutions01:29

Liquid–Solid Solutions

The process of a solid dissolving in a liquid to form a solution is governed by the solubility limit, which is the maximum amount of the solid substance, or solute, that can be dissolved in a specific volume of the liquid or solvent. As the solute dissolves, it reaches a point where no more solute can be dissolved at a given temperature - this is known as the saturation point. However, if further solute is added and it manages to dissolve, the solution becomes supersaturated. Supersaturated...
Electrochemical Systems01:24

Electrochemical Systems

Electrochemical systems provide a fascinating insight into the dynamic interplay of charged species within various phases. One notable example is the interaction between a membrane permeable to K⁺ ions but not to Cl⁻ ions, separating an aqueous KCl solution from pure water. As K⁺ ions diffuse through the membrane, they generate net charges on each phase, leading to a potential difference between them.Similarly, when a piece of Zn is immersed in an aqueous ZnSO₄ solution, the Zn metal, composed...