Formation and spread of aircraft-induced holes in clouds

Andrew J Heymsfield1, Gregory Thompson, Hugh Morrison

  • 1National Center for Atmospheric Research (NCAR), Boulder, CO 80301, USA. heyms1@ncar.ucar.edu

Science (New York, N.Y.)
|July 2, 2011
PubMed

Related Concept Videos

Lift01:23

Lift

Lift is a fundamental aerodynamic force that acts perpendicular to the direction of airflow. It plays a central role in achieving and sustaining flight and in stabilizing various vehicles. Lift primarily originates from pressure differences created across surfaces, such as an airfoil. A lower pressure region forms above the wing, while a higher pressure region forms below it, generating an upward force. This differential results from the shape and orientation of the airfoil, enabling the wing...
Boundary Layer Characteristics01:18

Boundary Layer Characteristics

When a fluid encounters a solid surface, a boundary layer forms due to the interaction between the fluid's motion and the stationary surface. This phenomenon is characterized by a thin region adjacent to the surface where viscous forces dominate, influencing the fluid's velocity profile. The development of the boundary layer begins at the leading edge of the surface and evolves as the fluid moves downstream.As the fluid flows over the surface, friction between the fluid and the wall slows down...
Free Jet01:14

Free Jet

Free jets describe the flow of liquid exiting a reservoir through an opening into the atmosphere without resistance. The velocity (v) of the liquid jet is derived using Bernoulli's principle and expressed as:
Excess Pressure Inside a Drop and a Bubble01:13

Excess Pressure Inside a Drop and a Bubble

The shape of a small drop of liquid can be considered spherical, neglecting the effect of gravity. This drop can further be considered as two equal hemispherical drops put together due to surface tension. The forces acting on the spherical drop are due to the pressure of the liquid inside the drop, the pressure due to air outside the drop, and the force due to the surface tension acting on the two hemispherical drops.
Precipitation Processes01:12

Precipitation Processes

The experimental conditions in a gravimetric analysis should be optimized to maximize the particle size and purity of the obtained precipitate. Ideally, the concentration of the precipitating reagent should be low with effective stirring to maintain low relative supersaturation for the growth of large crystals. In homogeneous precipitation, the precipitant is slowly generated by a chemical reaction in the solution to avoid local reagent excesses. For example, urea decomposes gradually to...
Plane Potential Flows01:23

Plane Potential Flows

Plane potential flows simplify fluid motion by assuming the fluid to be irrotational and incompressible. These characteristics allow these flows to be described by a velocity potential function, ϕ, representing the flow speed in a given direction, and a stream function, ψ, that visualizes the flow path, both governed by Laplace's equation. These parameters help in estimating flow patterns, velocity distributions, and pressure fields around various hydraulic structures.
Uniform Flow
Uniform flow...