Related Experiment Video
Updated: May 30, 2026

Visually Based Characterization of the Incipient Particle Motion in Regular Substrates: From Laminar to Turbulent Conditions
Published on: February 22, 2018
Ideal rate of collision of cylinders in simple shear flow
Vikram Singh1, Donald L Koch, Abraham D Stroock
1School of Chemical and Biomolecular Engineering, Cornell University, Ithaca, New York, USA.
Abstract:
The collision of particles influences the behavior of suspensions through the formation of aggregates for adhesive particles or through the contributions of solid-body contacts to the stress for nonadhesive particles. The simplest estimate of the collision rate, termed the ideal collision rate, is obtained when particles translate and rotate with the flow but have no hydrodynamic or colloidal interactions. Smoluchowski calculated the ideal collision frequency of spherical particles in 1917. So far, little work has been done to understand rate of collision for nonspherical particles. In this work, we calculate the ideal collision rate for cylindrical particles over a broad range of particle aspect ratios r defined as the ratio of length to diameter. Monte Carlo simulations are performed with initial relative positions and orientations that model the rate of approach of noninteracting particles following Jeffery orbits with several choices of the orbit distribution. The role of rotational motion of particles on collision frequency is elucidated by comparing the ideal collision rate calculations with similar calculations for nonrotating particles. It is shown that the ratio of the collision rate of cylinders to that of spheres that circumscribe the cylinders is proportional to 1/rr(e) for r ≫ 1 and r(e) for r ≪ 1. Here, r(e) is the effective aspect ratio defined as the aspect ratio of a spheroid having the same period of rotation as the cylinder. The effective aspect ratio of the cylindrical particles was determined using finite element calculations of the torque on nonrotating cylinders with their axes parallel to the velocity and velocity gradient directions. In addition to deriving the total collision rate, we categorize collisions as side-side, edge-side, and face-edge based on the initial point of contact. Most collisions are found to be side-edge for r ≫ 1 and face-edge for r ≪ 1, suggesting that nonlinear aggregates will develop if particles stick at the point of first contact.
More Related Videos
09:20The Assembly and Application of 'Shear Rings': A Novel Endothelial Model for Orbital, Unidirectional and Periodic Fluid Flow and Shear Stress
Published on: October 31, 2016
12:43Parallel-plate Flow Chamber and Continuous Flow Circuit to Evaluate Endothelial Progenitor Cells under Laminar Flow Shear Stress
Published on: January 17, 2012
Related Concept Videos
Couette Flow
Thin-Walled Hollow Shafts
Steady, Laminar Flow Between Parallel Plates
Steady, Laminar Flow in Circular Tubes
Newtonian Fluid: Problem Solving
A velocity gradient forms within the fluid when a Newtonian fluid is placed between two parallel plates, with...
Major Losses in Pipes
Fluid flow can be classified as laminar or turbulent, primarily based on the Reynolds number. This dimensionless number reflects the relative influence of inertial to viscous...