Isolation and structural characterization of the elusive 1:1 adduct of hydrazine and carbon dioxide

Byeongno Lee1, Seung Hee Kang, Donghyeon Kang

  • 1Department of Chemistry, Sogang University, Seoul 121-742, Korea.

Chemical Communications (Cambridge, England)
|September 16, 2011
PubMed

Related Concept Videos

Aldehydes and Ketones with HCN: Cyanohydrin Formation Overview01:32

Aldehydes and Ketones with HCN: Cyanohydrin Formation Overview

Cyanohydrins are compounds that contain –CN and –OH groups on the same carbon atom. They are formed by the nucleophilic addition of the cyanide ions to the carbonyl group. Cyanide ions are highly basic and nucleophilic and can be generated from HCN under aqueous conditions. However, since HCN is a weak acid, the number of cyanide ions generated is very small. Hence, a small amount of base or KCN/NaCN is added to HCN to increase the concentration of the cyanide ions in the reaction mixture.
Aldehydes and Ketones with HCN: Cyanohydrin Formation Mechanism01:10

Aldehydes and Ketones with HCN: Cyanohydrin Formation Mechanism

Cyanohydrins are formed when cyanide nucleophiles and carbonyl compounds like aldehydes and ketones react. A strong base, the cyanide ion, catalyzes cyanohydrin formation. The ions are generated from HCN under aqueous conditions. Once the cyanide ions are generated, the first step involves the nucleophilic attack of the cyanide ions on the electrophilic carbonyl carbon. This attack shifts the π electrons from the C=O to the oxygen atom forming the alkoxide ion intermediate. The alkoxide anion...
Aldehydes and Ketones to Alkanes: Wolff–Kishner Reduction01:09

Aldehydes and Ketones to Alkanes: Wolff–Kishner Reduction

Wolff–Kishner reduction involves converting aldehydes and ketones to alkanes using hydrazine and a base. The reaction converts a carbonyl group to a methylene group. The method was independently discovered by N. Kishner in 1911 and L. Wolff in 1912. The reduction is carried out in high-boiling solvents such as ethylene glycol and diethylene glycol because heat is required to deprotonate the N–H proton in one of the reaction steps.
¹³C NMR: ¹H–¹³C Decoupling01:04

¹³C NMR: ¹H–¹³C Decoupling

The probability of having two carbon-13 atoms next to each other is negligible because of the low natural abundance of carbon-13. Consequently, peak splitting due to carbon-carbon spin-spin coupling is not observed in spectra. However, protons up to three sigma bonds away split the carbon signal according to the n+1 rule, resulting in complicated spectra.
A broadband decoupling technique is used to simplify these complex, sometimes overlapping, signals. Broadband decoupling relies on a...
Aldehydes and Ketones with Water: Hydrate Formation01:20

Aldehydes and Ketones with Water: Hydrate Formation

An oxygen-based nucleophile, like water, can undergo addition reactions with aldehydes and ketones. The reaction leads to the formation of hydrates, also referred to as 1,1-diols or geminal diols.
The formation of hydrates is a reversible reaction. Hydrate formation is influenced by steric and electronic factors accompanying the alkyl substituents on the carbonyl group: The rate of hydrate formation increases with a decrease in the number of alkyl groups attached to the carbonyl carbon. Hence,...
2D NMR: Heteronuclear Single-Quantum Correlation Spectroscopy (HSQC)01:19

2D NMR: Heteronuclear Single-Quantum Correlation Spectroscopy (HSQC)

Heteronuclear single-quantum correlation spectroscopy (HSQC) is a 2D NMR technique that reveals one-bond correlations between hydrogen and a heteronucleus. The HSQC experiment is similar to the heteronuclear correlation experiment (HETCOR) but is more sensitive. In the HSQC spectrum, the proton chemical shift is plotted on the horizontal F2 axis, while the 13C chemical shift is plotted on the vertical F1 axis. The corresponding proton and 13C spectra are also shown. The HSQC contour plot does...