Related Experiment Video

Updated: May 27, 2026

Atom Probe Tomography Studies on the Cu(In,Ga)Se2 Grain Boundaries
09:51

Atom Probe Tomography Studies on the Cu(In,Ga)Se2 Grain Boundaries

Published on: April 22, 2013

Insight into unusual impurity absorbability of GeO(2) in GeO(2)∕Ge stacks

Shingo Ogawa, Taichi Suda, Takashi Yamamoto

    Applied Physics Letters
    |November 5, 2011
    PubMed

    More Related Videos

    Theoretical Calculation and Experimental Verification for Dislocation Reduction in Germanium Epitaxial Layers with Semicylindrical Voids on Silicon06:57

    Theoretical Calculation and Experimental Verification for Dislocation Reduction in Germanium Epitaxial Layers with Semicylindrical Voids on Silicon

    Published on: July 17, 2020

    Synthesis of Nine-atom Deltahedral Zintl Ions of Germanium and their Functionalization with Organic Groups08:15

    Synthesis of Nine-atom Deltahedral Zintl Ions of Germanium and their Functionalization with Organic Groups

    Published on: February 11, 2012

    Related Concept Videos

    Porosity and Absorption of Aggregate01:20

    Porosity and Absorption of Aggregate

    Aggregates contain pores of varying sizes; while some are completely enclosed within the particles, others open onto the surface, allowing water to penetrate. The porosity of aggregates is a major factor contributing to the overall porosity of concrete, given that aggregates constitute about three-quarters of concrete's volume.
    When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the aggregate...
    Imperfections in Crystal Structure: Stoichiometric Point Defects01:26

    Imperfections in Crystal Structure: Stoichiometric Point Defects

    Schottky defects arise when some lattice points in a crystal, such as those in NaCl, remain unoccupied, creating lattice vacancies without disturbing the overall electrical neutrality of the crystal. This defect is common in ionic crystals where the positive and negative ions are similar in size, as seen in sodium chloride and cesium chloride. The presence of Schottky defects enables the crystal to conduct electricity to a small extent through an ionic mechanism. Electric fields cause nearby...
    Imperfections in Crystal Structure: Non-Stoichiometric Defects01:29

    Imperfections in Crystal Structure: Non-Stoichiometric Defects

    Non-stoichiometric defects refer to a type of defect in the crystal structure of a compound where the ratio of its constituent elements deviates from the ideal stoichiometric ratio. There are two main types of non-stoichiometric defects: metal excess defects and metal deficiency defects.Metal excess defects occur when there is a slight surplus of metal ions than what is required by the stoichiometric ratio of the compound. For example, heating a sodium chloride crystal in sodium vapor results...
    Types of Coprecipitation01:10

    Types of Coprecipitation

    Coprecipitation is the contamination of a precipitate by otherwise soluble species and occurs via different processes. In colloidal precipitates, coprecipitation occurs via surface adsorption. For instance, barium sulfate has a primary layer of adsorbed barium ions and a secondary layer of nitrate counterions. This results in contamination of the precipitate by barium nitrate.
    Sometimes, ions in a crystal lattice can undergo isomorphous replacement by inclusions of similar charge and size. For...
    Gravimetry: Inorganic And Organic Precipitating Agents00:49

    Gravimetry: Inorganic And Organic Precipitating Agents

    In gravimetry, the precipitant is chosen carefully to obtain a pure solid that can be easily filtered. Common inorganic precipitants can be used to determine several cations and anions. In some cases, the formation of the same precipitate can be used to determine the cation and the anion. For example, the reaction of barium and chromate ions to give barium chromate is used to determine both barium and chromate. However, precipitates such as hydroxides, oxalates, and metal ammonium phosphates...
    Specific Gravity of Aggregate01:19

    Specific Gravity of Aggregate

    Aggregates typically contain pores, which can be either permeable or impermeable. Considering the pores in the aggregates, the specific gravity of aggregates is defined in three different forms, namely, bulk or gross specific gravity, apparent specific gravity, and absolute specific gravity.
    Bulk or gross specific gravity is calculated by taking the ratio of the mass of aggregates in the saturated surface-dry state to the total volume that includes both the solids and the voids within the...