[Quantitative analysis of Mn, Cr in steel based on laser-induced breakdown spectroscopy]

Quantitative analysis of trace elements such as manganese and chromium in steel was performed employing laser-induced breakdown spectroscopy (LIBS) technique in the present paper. The experimental measurements indicate that the optimal delay, focal plane and detecting position from the sample surface are 2 micros, -3.5 mm and 1.5 mm,respectively. Mn I: 403.07 nm and Cr I : 427.48 nm were selected as the analytical lines and their contents in the target steel sample were analyzed with traditional quantitative analysis and internal standard methods. Comparison of the results with two kinds of quantitatively analytical methods show that the coefficients of determination gained by internal standard method are 0.998 and 0.979 which are much better than the results obtained by traditional quantitative analysis method. According to the established calibration curve by internal standard method the detection limits of manganese and chromium calculated are 0.005% and 0.040 6%, respectively.