Related Experiment Video

Updated: May 26, 2026

A Computational Modeling Approach to Investigate the Influence of Hyperthermia on the Tumor Microenvironment
10:23

A Computational Modeling Approach to Investigate the Influence of Hyperthermia on the Tumor Microenvironment

Published on: December 1, 2023

Equation of state from the Potts-percolation model of a solid

Miron Kaufman1, H T Diep

  • 1Department of Physics, Cleveland State University, Cleveland, Ohio 44115, USA.

Physical Review. E, Statistical, Nonlinear, and Soft Matter Physics
|December 21, 2011
PubMed

More Related Videos

Knowledge Based Cloud FE Simulation of Sheet Metal Forming Processes11:05

Knowledge Based Cloud FE Simulation of Sheet Metal Forming Processes

Published on: December 13, 2016

Characterization of Thermal Transport in One-dimensional Solid Materials05:20

Characterization of Thermal Transport in One-dimensional Solid Materials

Published on: January 26, 2014

Related Concept Videos

Equation of State01:07

Equation of State

The equation of state is an equation that relates physical quantities, such as pressure, volume, temperature, and the number of moles, of a thermodynamics system with each other. The equation relating physical quantities with each other can be a simple mathematical expression or too complicated to express in mathematical form. In either case, a relationship between physical quantities exists. If the equation of state cannot be expressed in a mathematical form, then experimental data and...
Variables and Equations of State01:27

Variables and Equations of State

The physical state of a pure substance can be defined by certain state variables such as volume (V), pressure (p), temperature (T), and amount of substance (n). When two gases are separated by a movable wall, the gas with the higher pressure naturally compresses the gas with the lower pressure. This causes the high-pressure gas to expand and the low-pressure gas to compress until both gases achieve mechanical equilibrium. At this point, their pressures equalize, and the movement of the wall...
Solid–Solid Solutions01:24

Solid–Solid Solutions

The temperature-composition phase diagram of two solids, A and B, which are immiscible in the solid phase but form miscible liquids, shows that when the temperature is low, these two exist as separate, pure solids (A and B). As the temperature increases, they transition into a single-phase liquid solution where A and B coexist. Moving from point a1 to a2 in the phase diagram, the composition changes such that solid B begins to separate from the solution, enriching the remaining liquid with A.
Phase Transitions: Sublimation and Deposition02:33

Phase Transitions: Sublimation and Deposition

Some solids can transition directly into the gaseous state, bypassing the liquid state, via a process known as sublimation. At room temperature and standard pressure, a piece of dry ice (solid CO2) sublimes, appearing to gradually disappear without ever forming any liquid. Snow and ice sublimate at temperatures below the melting point of water, a slow process that may be accelerated by winds and the reduced atmospheric pressures at high altitudes. When solid iodine is warmed, the solid sublimes...
Poisson's And Laplace's Equation01:25

Poisson's And Laplace's Equation

The electric potential of the system can be calculated by relating it to the electric charge densities that give rise to the electric potential. The differential form of Gauss's law expresses the electric field's divergence in terms of the electric charge density.
Clausius-Clapeyron Equation02:35

Clausius-Clapeyron Equation

The equilibrium between a liquid and its vapor depends on the temperature of the system; a rise in temperature causes a corresponding rise in the vapor pressure of its liquid. The Clausius-Clapeyron equation gives the quantitative relation between a substance’s vapor pressure (P) and its temperature (T); it predicts the rate at which vapor pressure increases per unit increase in temperature.