Related Experiment Video
Updated: May 26, 2026
Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material
Published on: December 20, 2024
An in vitro assessment of a ceramic-pressed-to-metal system as an alternative to conventional metal ceramic systems
1Department of Fixed Prosthodontics, Faculty of Oral and Dental Medicine, Cairo, Egypt. nadiafahmyz@hotmail.com
Purpose:
This article reviews a press-on metal (POM) ceramic versus a conventional veneering system regarding marginal gaps, fracture resistance, microhardness, and surface roughness. This was done to provide clinical recommendations for its use.
Materials And Methods:
Forty crowns were constructed and divided into two main groups according to the metal coping design. Group 1: Twenty metal copings with metal margin extending to the axiogingival line angle. Group 2: Twenty metal copings with metal margin 1 mm occlusal to the axiogingival line angle. The specimens of each group were further subdivided into two subgroups (A and B) according to the veneering porcelain used. The vertical marginal gaps of the crowns were measured after veneering placement. For fracture resistance testing, the crowns were subjected to compressive load to failure. Representative samples of the two main groups were selected to measure surface roughness and microhardness.
Results:
No statistically significant difference was evident regarding the vertical marginal gap distance in relation to the margin design of both tested groups (p= 0.249, p= 0.815); however, the POM veneer group with metal porcelain margin showed statistically lower marginal gaps than the conventional ceramic veneer group (p= 0.043). Fracture resistance values did not show statistically significant difference regarding the margin design (p= 0.858, p= 0.659) or type of the ceramic veneer material (p= 0.592, p= 0.165). Both groups showed no significant difference in their mean roughness values (p= 0.235). Conventional ceramics showed statistically significantly higher mean microhardness values than POM did (p= 0.008).
Conclusion:
This study showed superior marginal adaptation, decreased microhardness, and similar load to failure and roughness values of the POM ceramic system. Moreover, considerable ease and speed of fabrication of this system were evident. The high variation in range values of some tested groups is among the limitations of this study, along with the lack of clinical trials to test the system in vivo.
