Related Experiment Video
Updated: May 25, 2026
Biofilm Removal Using Carbon Dioxide Aerosols without Nitrogen Purge
Published on: November 6, 2016
Decontamination of room air and adjoining wall surfaces by nebulizing hydrogen peroxide
Torsten Koburger1, Harald Below, Tina Dornquast
1Hygiene Nord GmbH, Greifswald, Germany.
Aim:
In 2010, the ASP GLOSAIR(TM) 400 was introduced in Germany for nebulizing hydrogen peroxide (H(2)O(2)). Since there were no results of practical experience, the new method was to be checked under practical conditions for its effectiveness in decontaminating air in rooms, infested with mold after water damage and, at the same time, under experimentally controlled conditions, test surfaces, contaminated with Aspergillus brasiliensis.
Method:
After the nebulizer was used in two rooms with a massive mold infestation, the air colony count was determined (MAS-100(®) Zinsser Analytik) and, at the same time, the mold infestation in samples of wall plaster.As part of this controlled study, test surfaces contaminated with Aspergillus brasiliensis were positioned vertically and horizontally in a test room. The effectiveness of the nebulization (5-6% H(2)O(2) for 2 hours) was tested on these surfaces according to EN 13697.
Results:
In a massive mold infestation resulting from water damage (worst case), an approximately 9-fold decrease in the mold content and an approximately 13-fold decrease in the number of colony-forming units (sum of the bacteria + fungi) could be detected in the room air immediately after the nebulizing was finished. Even in samples of wall and joint plaster, the molds were reduced, although to a distinctly lesser extent. By indoor nebulization of 5-6% H(2)O(2), A. brasiliensis was reduced >4 log on vertical and horizontal surfaces.
Discussion:
In rooms with a massive mold infestation, the ASP GLOSAIR(TM) 400 system is suitable for attaining a clear reduction in the fungal and bacterial room air load, lasting for a week. On vertical and horizontal surfaces, contaminated experimentally with A. brasiliensis, a reduction of >4 lg is achieved. As a load of 10(4) to 10(5) fungal spores is unlikely to occur on pre-cleaned surfaces, the GLOSAIR(TM) 400 can be considered a suitable complementary process for the substantial reduction of fungal contamination.
Related Concept Videos
01:25Transmission-based Precautions II: Airborne and Protective Environment
Airborne precautions:
Use airborne precautions when treating patients known or suspected to have diseases that spread through the air—for example, tuberculosis or measles. These organisms are present in smaller droplets expelled by an infected person and...
01:30Administering Oxygen by Mask
Administering oxygen by mask is a common nursing intervention that provides supplemental oxygen to patients with respiratory distress or chronic lung conditions. This procedure involves delivering oxygen at a specified rate through a face mask connected to an oxygen source.
Equipment
The equipment necessary for this procedure includes:
01:26Physical Methods for Controlling Microbial Growth: Radiation and Filtration
01:23Hand hygiene
Hand washing...
01:30Cleaning, Sterilization, and Disinfection
Cleaning
The cleaning process usually involves using water with detergents or enzymatic cleaner and removing foreign material from objects and surfaces, including organic material such as body fluids or inorganic material like soil. Cleaning is performed before high-level disinfection and sterilization because foreign materials on the cover of the devices interfere with process...
01:30Methods of Sterilization II: Chemical Methods
Using chemical sterilization rather than heat to clean out equipment is recommended. It eradicates and removes all bacteria,...