Related Experiment Video

Updated: May 25, 2026

A Lightweight, Headphones-based System for Manipulating Auditory Feedback in Songbirds
10:13

A Lightweight, Headphones-based System for Manipulating Auditory Feedback in Songbirds

Published on: November 26, 2012

A new delayless sub-band filtering method for cancelling the effect of feedback path in hearing aid systems

Soudeh A Khoubrouy, Issa M S Panahi, Ali A Milani

    Annual International Conference of the IEEE Engineering in Medicine and Biology Society. IEEE Engineering in Medicine and Biology Society. Annual International Conference
    |January 19, 2012
    PubMed

    More Related Videos

    An Automated System for Sound Localization Testing in Hearing-Impaired Listeners07:52

    An Automated System for Sound Localization Testing in Hearing-Impaired Listeners

    Published on: March 13, 2026

    A Low Cost Setup for Behavioral Audiometry in Rodents09:23

    A Low Cost Setup for Behavioral Audiometry in Rodents

    Published on: October 16, 2012

    Related Concept Videos

    Passive Filters01:27

    Passive Filters

    Passive filters are utilized to shape the frequency spectrum of signals across a diverse array of applications. These filters, using only passive elements like resistors (R), inductors (L), and capacitors (C), are capable of selectively allowing or blocking certain frequency ranges without the need for external power sources.
    Low-Pass Filters
    Low-pass filters are designed to transmit signals with frequencies lower than the cutoff frequency, ωc, and attenuate those above it. The cutoff frequency...
    Parallel Resonance01:23

    Parallel Resonance

    The parallel RLC circuit is an arrangement where the resistor (R), inductor (L), and capacitor (C) are all connected to the same nodes and, as a result, share the same voltage across them. The parallel RLC circuit is analyzed in terms of admittance (Y), which reflects the ease with which current can flow. The admittance is given by:
    Active Filters01:25

    Active Filters

    Active filters are electronic circuits that use operational amplifiers (op-amps), resistors, and capacitors to filter out unwanted frequency components from a signal. A first-order low-pass active filter is designed to pass signals with a frequency lower than a certain cutoff frequency and attenuate frequencies higher than that cutoff frequency. The transfer function for a first-order low-pass active filter is:
    Second-order Op Amp Circuits01:19

    Second-order Op Amp Circuits

    Implementing second-order low-pass filters in audio systems is crucial in refining audio signals by eliminating undesirable high-frequency noise. These filters typically involve second-order op-amp circuits configured as voltage followers, encompassing two nodes with distinct storage elements.
    The analysis of such circuits follows a systematic approach, similar to the second-order RLC circuits. In practical scenarios, bulky inductors are rarely employed due to their size and weight. This means...
    Bandpass Sampling01:17

    Bandpass Sampling

    In signal processing, bandpass sampling is an effective technique for sampling signals that have most of their energy concentrated within a narrow frequency band. This type of signal is known as a bandpass signal. The key principle of bandpass sampling involves sampling the signal at a rate that is greater than twice the signal's bandwidth to prevent aliasing.
    A bandpass signal has a spectrum with a lower frequency limit, denoted as ω1, and an upper frequency limit, denoted as ω2. The spectrum...
    Op Amp AC Circuits01:18

    Op Amp AC Circuits

    Within an audio system, the filter circuit plays a pivotal role in processing the amplified audio signal from an amplifier. Its primary function is significantly attenuating signal components with lower frequencies, thereby shaping the audio output. This circuit's operations are examined, focusing on the fundamental filter configuration. This configuration involves an operational amplifier arranged in an inverting setup coupled with resistors (R1 and R2) and a capacitor (C1).