Related Experiment Video
Updated: May 25, 2026

Microtensiometer for Confocal Microscopy Visualization of Dynamic Interfaces
Published on: September 9, 2022
Using bulk convection in a microtensiometer to approach kinetic-limited surfactant dynamics at fluid-fluid interfaces
Nicolas J Alvarez1, Douglas R Vogus, Lynn M Walker
1Department of Chemical Engineering, Carnegie Mellon University, Pittsburgh, PA 15213, USA.
Abstract:
The impact of transport of surfactants to fluid-fluid interfaces is complex to assess and model, as many processes are in the regime where kinetics, diffusion and convection are comparable. Using the principle that the timescale for diffusion decreases with increasing curvature, we previously developed a microtensiometer to accurately measure fundamental transport coefficients via dynamic surface tension at spherical microscale liquid-fluid interfaces. In the present study, we use a low Reynolds number flow in the bulk solution to further increase the rate of diffusion. Dynamic surface tension is measured as a function of Peclet number and the results are compared with a simplified convection-diffusion model. Although a transition from diffusion to kinetic-limited transport is not observed experimentally for the surfactants considered, lower bounds on the adsorption and desorption rate constants are determined that are much larger than previously reported rate constants. The results show that the details of the flow field do not need to be controlled as long as the local Reynolds number is low. Aside from other pragmatic advantages, this experimental tool and analysis allows the governing mechanisms of surfactant transport at liquid-fluid interfaces to be quantified using flow near the interface to decrease the length scale for diffusion, separating the relevant timescales.
More Related Videos
11:03An Analog Macroscopic Technique for Studying Molecular Hydrodynamic Processes in Dense Gases and Liquids
Published on: December 4, 2017
06:31Studying Surfactant Effects on Hydrate Crystallization at Oil-Water Interfaces Using a Low-Cost Integrated Modular Peltier Device
Published on: March 18, 2020