Differential student attrition and differential exposure mask effects of problem-based learning in curriculum

Henk G Schmidt1, Arno M M Muijtjens, Cees P M Van der Vleuten

  • 1Department of Psychology, Erasmus University, Rotterdam, The Netherlands. schmidt@fsw.eur.nl

Abstract

Related Concept Videos

Theory of Attribution II: Kelley's Covariation Theory01:29

Theory of Attribution II: Kelley's Covariation Theory

Attribution theory plays a crucial role in social psychology, helping to explain how individuals interpret the causes of behavior. One prominent model within this field is Harold Kelley's covariation theory, which provides a systematic approach to determining whether internal traits or external circumstances drive a person's actions. The model posits that individuals rely on three key types of information—consensus, consistency, and distinctiveness—to make these judgments.Consensus: Comparing...
Blinding01:11

Blinding

Blinding is a commonly used method of not telling participants which treatment a subject is receiving. Blinding is a critical part of a randomized control trial or RCT. It reduces the bias that affects the results. In an RCT, blinding is used in the form of a placebo. A placebo effect occurs when untreated subjects falsely believe they have received the treatment and report improved symptoms. A placebo or a dummy treatment is administered to subjects to negate the bias caused by such an effect.
Longitudinal Research02:20

Longitudinal Research

Sometimes we want to see how people change over time, as in studies of human development and lifespan. When we test the same group of individuals repeatedly over an extended period of time, we are conducting longitudinal research. Longitudinal research is a research design in which data-gathering is administered repeatedly over an extended period of time. For example, we may survey a group of individuals about their dietary habits at age 20, retest them a decade later at age 30, and then again...
Group Design02:01

Group Design

The most basic experimental design involves two groups: the experimental group and the control group. The two groups are designed to be the same except for one difference— experimental manipulation. The experimental group gets the experimental manipulation—that is, the treatment or variable being tested—and the control group does not. Since experimental manipulation is the only difference between the experimental and control groups, we can be sure that any differences between the two are due to...
Blind Procedures02:07

Blind Procedures

Ideally, the people who observe and record the children’s behavior are unaware of who was assigned to the experimental or control group, in order to control for experimenter bias. Experimenter bias refers to the possibility that a researcher’s expectations might skew the results of the study. Remember, conducting an experiment requires a lot of planning, and the people involved in the research project have a vested interest in supporting their hypotheses. If the observers knew which child was...
Comparing Experimental Results: Student's t-Test01:09

Comparing Experimental Results: Student's t-Test

The t-test is a statistical method used to compare the sample mean with a population mean or compare two means from two data sets. The test statistic is calculated from the standard deviation, mean, and number of measurements in the data set at a selected confidence interval and then compared to a table of critical values at this confidence level. If the test statistic is smaller than the critical value, the null hypothesis is accepted. In this case, we state that the difference between the...