Related Experiment Video
Updated: May 20, 2026
Rapid Mix Preparation of Bioinspired Nanoscale Hydroxyapatite for Biomedical Applications
Published on: February 23, 2017
Characterization of thermal sprayed hydroxyapatite coatings on some biomedical implant materials
Tejinder Pal Singh1, Harpreet Singh, Hazoor Singh
1Gulzar Institute of Engineering & Technology, Ludhiana, Punjab - India.
Purpose:
To characterize two thermal sprayed coatings of different particle-sized hydroxyapatite on some biomedical implant materials.
Methods:
Characterization of the as-sprayed coatings was performed using x-ray diffractometer (XRD), scanning electron microscopy/energy dispersive spectroscopy (SEM/EDS), and x-ray mapping techniques. Bond strength of the sprayed coatings measured as per ASTM-C633 standard and cell culture studies were performed to access the biocompatibility of the coatings.
Results:
The results indicated that, HA coatings of 10 μm particle sized powder were completely amorphous, while that of 30 μm sized powder consisted of crystalline HA with minor tetracalcium phosphate (TTCP) and tricalcium phosphate (TCP) phases. This flame spray HA-A and HA-B coatings exhibited higher bond strength (67.8 and 49.3 MPa respectively) in comparison with other thermal spray HA coating techniques reported in literature. In-vitro biocompatibility studies revealed that HA-B coated specimens had good biocompatibility with a human osteosarcoma cell line KHOSNP (R-970-5).
Conclusions:
These observations show that particle size of HA powders have a significant effect on the phase composition, microstructure, roughness and biocompatibility of deposited coatings. HA-B coatings were found to be metallurgically better than the HA-A coating from the point of view of biomedical applications.
