Fixed-point drift and hysteresis in frequency-scaled unimanual coordination
1Department of Health and Human Performance, The University of Texas at Brownsville, Brownsville, TX 78520, USA. Eric.James@utb.edu
Abstract:
Research on human rhythmic coordination has shown that the in-phase and antiphase coordination modes are typically stable and that the coordination of asymmetric effectors frequently exhibits fixed-point drift. The author extended research on symmetry breaking in coordination dynamics by examining a frequency-scaled unimanual pronation-supination task. The results showed symmetry breaking and fixed-point drift, with the radioulnar joint increasingly more phase advanced than the shoulder with increments in movement frequency. Hysteresis was also observed, as the relative phase patterns produced at 3 of the 4 movement frequencies were lower in the upward frequency scaling direction than in the downward direction. These results showed that the dynamic properties of symmetry breaking and fixed-point drift in unimanual pronation-supination movements were consistent with prior research and modeling. The hysteresis effect was explained as potentially being due to the control structures that organize this redundant coordination task.
More Related Videos
07:28A Method for Evaluating Timeliness and Accuracy of Volitional Motor Responses to Vibrotactile Stimuli
Published on: August 2, 2016
11:06A Human-machine-interface Integrating Low-cost Sensors with a Neuromuscular Electrical Stimulation System for Post-stroke Balance Rehabilitation
Published on: April 12, 2016
Related Concept Videos
Time and frequency -Domain Interpretation of PI Control
Acting as a low-pass filter, the PI controller slows the system's response and extends settling times. This requires careful...
Time-Domain Interpretation of PD Control
Consider the example of control of motor torque. Initially, a positive...
Time and frequency -Domain Interpretation of Phase-lead Control
The design of phase-lead control involves the strategic placement of poles and zeros to balance steady-state error and system...
Forced Oscillations
Time and frequency -Domain Interpretation of Phase-lag Control
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any finite,...
Load-frequency control
