Related Experiment Video
Updated: May 19, 2026
Construction of a Realistic, Whole-Body, Three-Dimensional Equine Skeletal Model using Computed Tomography Data
Published on: February 25, 2021
Finite element analysis of stress in the equine proximal phalanx
L M S O'Hare1, P G Cox, N Jeffery
1School of Veterinary Science, Faculty of Health and Life Sciences, University of Liverpool, UK. xp0u80ab@liv.ac.uk
Reasons For Performing Study:
To improve understanding of the internal structure of the proximal phalanx (P1), response of the bone to load and possible relation to the pathogenesis of fractures in P1.
Objectives:
To model the P1 and replicate the loads experienced by the bone in stance, walk, trot and gallop using finite element analysis.
Methods:
The geometry of the P1 was captured using micro-computed tomography (μCT) and was reconstructed in 3 dimensions. Values for material properties and forces experienced at stance, walk, trot and gallop were taken from the literature and were applied to the reconstructed model. Using the same total load across the proximal articular surface, the model was solved with and without loading of the sagittal groove. Biomechanical performance was then simulated with finite element analysis and evaluated in terms of von Mises stress maps.
Results:
Compared with the lowest force simulation equivalent to stance, the effects of the gallop force showed higher levels of stress along the sagittal groove and on the palmar surface just distal to the sagittal groove in both models, with and without the sagittal groove loaded. The results highlighted an area of bone on the dorsal aspect of P1 that experiences lower stress compared with the rest of the dorsal surface, an effect that was much more apparent when the sagittal groove was not loaded. Qualitative comparison of the models revealed minimal difference in the pattern of von Mises stress between the loaded and unloaded groove models.
Conclusions:
The study demonstrates a finite element model of P1 that produces results consistent with clinical observation. The simulated high stress levels associated with the sagittal groove correspond to the most common site for fractures in the equine P1.
Potential Relevance:
With refinement of the model and further investigation, it may be possible to improve understanding of the behaviour of P1 under loading conditions that more closely simulate those experienced in the living animal, leading to a more solid understanding of fractures of P1.
Related Concept Videos
01:16Flexural Stress
Hooke's Law states that within the material's elastic limits, stress is directly proportional to strain. In a member experiencing a bending moment, the strain at any point is relative to its distance...
01:15Stress: General Loading Conditions
The shearing force, possessing potential directionality within the plane of the section, is simplified into two component forces running parallel to the x and y axes.
01:23Components of Stress
Interestingly, the hidden cube faces also experience these stresses, equal and opposite to those on the...
01:23Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
01:15Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity
01:18Stress Concentrations in Circular Shafts