Related Experiment Video

Updated: May 18, 2026

A Simple Approach to Perform TEER Measurements Using a Self-Made Volt-Amperemeter with Programmable Output Frequency
07:43

A Simple Approach to Perform TEER Measurements Using a Self-Made Volt-Amperemeter with Programmable Output Frequency

Published on: October 5, 2019

On the effect of body capacitance to ground in tetrapolar bioimpedance measurements

Carles Aliau-Bonet1, Ramon Pallas-Areny

  • 1BarcelonaTech-UPC, Universitat Politècnica de Catalunya, Barcelona 08034, Spain. carles.aliau@upc.edu

IEEE Transactions on Bio-Medical Engineering
|September 8, 2012
PubMed

More Related Videos

Evaluation of Fluid Overload by Bioelectrical Impedance Vectorial Analysis07:17

Evaluation of Fluid Overload by Bioelectrical Impedance Vectorial Analysis

Published on: August 17, 2022

Related Concept Videos

Bode Plots Construction01:24

Bode Plots Construction

The Bode plot is an essential tool in control system analysis, mapping the frequency response of a system through a magnitude plot and a phase plot, both against a logarithmic frequency axis. To construct a Bode plot, consider the transfer function H(ω):
Equivalent Capacitance01:19

Equivalent Capacitance

Multiple capacitors can be connected in a circuit in series or parallel configuration. When the capacitor combination is connected to a battery, the potential drop across each capacitor and the magnitude of charge stored in the individual capacitor depends on the type of the connection. The capacitor combination is replaced by a single equivalent capacitor that stores the same amount of charge as the combination for a given potential difference.
The following strategies are adopted to calculate...
Equivalent Capacitance01:19

Equivalent Capacitance

From the study of resistive circuits, it is understood that employing a series-parallel combination serves as an effective strategy for simplifying circuits. Capacitors can be arranged within a circuit in one of two ways: a series configuration or a parallel configuration. The way these capacitors are connected to a battery will influence both the potential drop across each individual capacitor and the size of the charge that each capacitor can store. This is determined by the specific type of...
Dielectric Polarization in a Capacitor01:31

Dielectric Polarization in a Capacitor

The presence of a dielectric medium in a capacitor not only changes the voltage and capacitance but also affects the electric field. In general, dielectrics can be of two types: polar and nonpolar. In a polar dielectric, the positive and negative charges in the molecules are separated by a distance and hence have a permanent dipole moment. In contrast, no such charge separation exists in a nonpolar dielectric, however the nonpolar molecules get polarized in the presence of an external electric...
Capacitors01:15

Capacitors

Capacitors play a crucial role in car radios, where they filter and store frequencies to ensure clear signal reception. Essentially serving as energy storage devices, capacitors store energy within their electric field and are composed of two parallel conducting plates separated by a dielectric.
When a voltage source is connected to a capacitor, positive and negative charges accumulate on the opposite plates. This accumulation generates a potential difference that equals the product of the...
Capacitance: Single-Phase And Three-Phase Line01:25

Capacitance: Single-Phase And Three-Phase Line

In electrical power systems, understanding the capacitance of transmission lines is fundamental for efficient operation.
Single-Phase Lines
Consider a single-phase, two-wire transmission line with equal phase spacing energized by a voltage source. One conductor carries a uniform positive charge, while the other carries an equal negative charge. The capacitance C of the line can be derived from the voltage V between the conductors. For a one-meter section of the line, the capacitance is given...