Following butter flavour deterioration with an acoustic wave sensor

Cláudia R B S Gaspar1, M Teresa S R Gomes

  • 1CESAM & Department of Chemistry, University of Aveiro, 3810-193 Aveiro, Portugal.

Talanta
|September 13, 2012
PubMed

Related Concept Videos

Echo01:06

Echo

The human ear cannot distinguish between two sources of sound if they happen to reach within a specific time interval, typically 0.1 seconds apart. More than this, and they are perceived as separate sources.
Imagine the sound is reflected back to the ears. Assuming that the source is very close to the human, the difference between hearing the two sounds—the emitted sound and the reflected sound—may be more than the minimum time for perceiving distinct sounds. If this is the case, then the...
Biodeterioration01:28

Biodeterioration

Biodeterioration refers to the unwanted alteration of materials caused by microorganisms—especially fungi—which damage both organic substrates (paper, wood, textiles) and inorganic ones (stone, plaster, glass). Unlike abiotic decay, biodeterioration results from biological activity that produces physical disruption and chemical degradation.Physical deterioration occurs as fungal hyphae penetrate pores, cracks, and surface irregularities. Hyphal turgor pressure, thigmotropic growth along...
Discrete Fourier Transform01:15

Discrete Fourier Transform

The Discrete Fourier Transform (DFT) is a fundamental tool in signal processing, extending the discrete-time Fourier transform by evaluating discrete signals at uniformly spaced frequency intervals. This transformation converts a finite sequence of time-domain samples into frequency components, each representing complex sinusoids ordered by frequency. The DFT translates these sequences into the frequency domain, effectively indicating the magnitude and phase of each frequency component present...
Wheatstone Bridge01:29

Wheatstone Bridge

An ohmmeter is a resistance-measuring device. It works by applying a voltage to a resistor of unknown resistance and measuring the current across the resistor. The resistance value is deduced using Ohm's law. Usually, the standard configuration of an ohmmeter comprises a voltmeter or an ammeter. However, such configurations are limited in accuracy because the meters alter the voltage applied to the resistor and the current that flows through it.
Thus, for accurate resistance measurements, a...
Types of Damping01:20

Types of Damping

If the amount of damping in a system is gradually increased, the period and frequency start to become affected because damping opposes, and hence slows, the back and forth motion (the net force is smaller in both directions). If there is a very large amount of damping, the system does not even oscillate; instead, it slowly moves toward equilibrium. In brief, an overdamped system moves slowly towards equilibrium, whereas an underdamped system moves quickly to equilibrium but will oscillate about...
Microbial Spoilage of Food01:23

Microbial Spoilage of Food

Microbial food spoilage refers to the degradation of food quality resulting from the metabolic activity of microorganisms such as bacteria, yeasts, and molds. These microbes proliferate on various food substrates depending on factors such as moisture content, nutrient availability, and storage conditions, leading to undesirable sensory and structural changes.Bacteria are primary agents of spoilage in high-moisture, nutrient-dense foods like meat, milk, and vegetables. Microbial spoilage occurs...