Related Experiment Video
Updated: May 18, 2026

Atomic Scale Structural Studies of Macromolecular Assemblies by Solid-state Nuclear Magnetic Resonance Spectroscopy
Published on: September 17, 2017
Detailed analysis of the TIMES and TIMES0 high-resolution MAS methods for high-resolution proton NMR
Xingyu Lu1, Olivier Lafon, Julien Trébosc
1UCCS (CNRS-8181), University Lille North of France, Villeneuve d'Ascq 59652, France.
Abstract:
We analyze and compare the specifications of TIMES and TIMES(0) proton high-resolution NMR methods for solid-state samples. This comparison is performed in terms of resolution versus magic-angle spinning (MAS) spinning speed, ν(R), rf-field amplitude, ν(1), and tilt-angle for the effective rf-field, θ(p). The chemical-shift and homo-nuclear dipolar scaling factors are calculated for both methods. For all MAS speeds, the best resolution is always observed with rf-field of ν(1)≈120-130 kHz. At slow MAS speed (ν(R)≤10 kHz), the best resolution is observed for a tilt-angle of θ(P)≈90°. At moderate spinning speed (15≤ν(R)≤35 kHz), θ(P)≈55° gives the best resolution. At higher MAS speed (ν(R)≥60 kHz), with TIMES and TIMES(0) the best resolution is obtained for θ(P)≤40°; but we then recommend TIMES(0), owing to its simpler set-up. We also show that in addition to the usual high rf-field regime (ν(1)≈120-130 kHz), another low rf-regime (ν(1)≈40-50 kHz) exists at MAS speed higher than ν(R)≥60 kHz, which also gives a good (1)H resolution. This low rf-regime should be useful for multi-dimensional analyses of bio-molecules with (1)H detection under high-resolution, in order to limit the heating of the sample.
Related Concept Videos
High-Resolution Mass Spectrometry (HRMS)
¹H NMR of Labile Protons: Temporal Resolution
The –OH proton in alcohols typically appears in the range of δ 2 to 5 ppm but can vary depending on the specific...
Mass Analyzers: Overview
Proton (¹H) NMR: Chemical Shift
Absorption signals of all the protium nuclei in a...
NMR Spectrometers: Resolution and Error Correction
¹H NMR: Complex Splitting
Splitting diagrams or splitting tree diagrams are routinely used to depict such complex couplings. While drawing splitting diagrams, the splitting with the larger coupling constant is usually applied first.
