The hyoplatysmal ligament: characterization and biomechanical properties

Plakins are large proteins with binding domains for microtubules, microfilaments, intermediate filaments, and membrane-associated protein complexes at cell junctions. Plakin functions are evolutionarily conserved and are primarily involved in organizing the different components of the cytoskeleton by crosslinking them to each other and connecting them to the cell-matrix and cell adhesion complexes. They are also known to interact with signal transducers, serve as scaffolds for signaling...

Hooke's law, a pivotal principle in material science, establishes that the strain a material undergoes is directly proportional to the applied stress, defined by a factor called the modulus of elasticity or Young's modulus.

The generalized Hooke's Law is a broadened version of Hooke's Law, which extends to all types of stress and in every direction. Consider an isotropic material shaped into a cube subjected to multiaxial loading. In this scenario, normal stresses are exerted along the three coordinate axes. As a result of these stresses, the cubic shape deforms into a rectangular parallelepiped. Despite this deformation, the new shape maintains equal sides, and there is a normal strain in the direction of the...

The hyoid bone is a small U-shaped bone located in the upper neck at the level of the inferior mandible, with its tips pointing posteriorly. It does not directly articulate with any other bone in the body. The hyoid acts as the attachment site for the tongue, the larynx, and the pharynx. It is held in position by a series of small muscles attached from above or below. These muscles help to move the hyoid up/down or forward/back in coordination with movements of the tongue, larynx, and pharynx...

The behavior of elastoplastic materials under bending stresses, particularly in structural members with rectangular cross-sections, is crucial for predicting material responses and understanding failure modes. Initially, when a bending moment is applied, the stress distribution across the section follows Hooke's Law and is linear and elastic. This distribution means the stress increases from the neutral axis to the maximum at the outer fibers, up to the elastic limit.
As the bending moment...

When a structural member undergoes plastic deformation due to bending, it is crucial to understand the position of the neutral axis and the stress distribution. This member, characterized by a single plane of symmetry, exhibits a uniform stress distribution, with negative stress above the neutral axis and positive stress below. Notably, the neutral axis does not align with the centroid of the cross-section. This misalignment is typical in cases where the cross-section is not rectangular or...