Related Experiment Video
Updated: May 18, 2026
A Complete Method for Evaluating the Performance of Photocatalysts for the Degradation of Antibiotics in Environmental Remediation
Published on: October 6, 2022
Disinfection of water using Pt- and Ag-doped TiO2 photocatalysts
Rominder P S Suri1, Hilary M Thornton, M Muruganandham
1Water & Environmental Technology (WET) Center, Department of Civil and Environmental Engineering, Temple University, Philadelphia, PA 19122, USA. rsuri@temple.edu
Abstract:
In this article we have reported heterogeneous photocatalytic disinfection using pristine and Ag- and Pt-doped nano TiO2 under near-UV light and solar light irradiation. Disinfection experiments were conducted in slurry reactors with Escherichia coli, artificial light and sunlight. The influence of various amounts of Pt and Ag loading (0.5% to 5%) on the E. coli inactivation was examined and results indicated that 5% Pt-TiO2 and 0.5% Ag-TiO2 showed the highest photocatalytic E. coli inactivation. The Pt- and Ag-doped photocatalysts were characterized using XPS and TEM analysis. The influence of experimental parameters such as various photocatalysts, photocatalyst concentration, reactor geometry effect, pH and temperature on the photocatalytic disinfection was studied. The experimental results show that sunlight or near-UV light with TiO2 photocatalyst strongly inactivates E. coli. The Ag-TiO2 photocatalyst was the most efficient photocatalyst tested for bactericidal activity. A plausible mechanism ofphotocatalysed E. coli inactivation is discussed. In conclusion, the doped nano TiO2 photocatalysts is a potential candidate for E. coli inactivation.
