MP2 energy and density for large molecular systems with internal error control using the Divide-Expand-Consolidate

Kasper Kristensen1, Ida-Marie Høyvik, Branislav Jansik

  • 1qLEAP-Center for Theoretical Chemistry, Department of Chemistry, Aarhus University, Langelandsgade 140, DK-8000 Aarhus C, Denmark. kasperk@chem.au.dk

Related Concept Videos

Propagation of Uncertainty from Systematic Error01:10

Propagation of Uncertainty from Systematic Error

The atomic mass of an element varies due to the relative ratio of its isotopes. A sample's relative proportion of oxygen isotopes influences its average atomic mass. For instance, if we were to measure the atomic mass of oxygen from a sample, the mass would be a weighted average of the isotopic masses of oxygen in that sample. Since a single sample is not likely to perfectly reflect the true atomic mass of oxygen for all the molecules of oxygen on Earth, the mass we obtain from this particular...
Polymers: Molecular Weight Distribution01:10

Polymers: Molecular Weight Distribution

For any given polymer, the weight average molecular weight (Mw) is higher than, if not equal to, the number average molecular weight (Mn). The only situation in which the weight average molecular weight and the number average molecular weight are equal is when a polymer consists only of chains with equal molecular weight. However, this never happens in a synthetic polymer, since it is difficult to control the polymerization process up to a molecular level with accuracy to a hundred percent.
The Molecular Nature of Internal Energy01:27

The Molecular Nature of Internal Energy

The internal energy of a molecule is determined by its degrees of freedom, including translational, rotational, and vibrational motions. In addition to these kinetic activities, the energy of molecules is also shaped by electronic energy, intermolecular forces, and the rest-mass energy of electrons and nuclei. These factors collectively influence the energy state of the molecules. The equipartition theorem of classical mechanics provides insight into this energy distribution. It posits that the...
Determination of Molar Masses of Polymers II01:27

Determination of Molar Masses of Polymers II

Polymer samples typically consist of macromolecular chains with a distribution of lengths, resulting in a range of molar masses rather than a single discrete value. Conventional descriptors such as the number-average molar mass and weight-average molar mass quantify this distribution but do not fully capture polymer behavior in solution..The viscosity-average molar mass provides a more realistic description of polymer behavior in solution because it accounts for the enhanced contribution of...
Molecular Weight of Step-Growth Polymers01:08

Molecular Weight of Step-Growth Polymers

Step growth polymerization involves bi or multifunctional monomers. Bifunctional monomers react to form linear step growth polymers, whereas multifunctional monomers react to form non-linear or branched polymers.
As the step-growth polymerization involves step-wise condensation of monomers, the molecular weight also builds up eventually. Consequently, high molecular weight polymers are obtained at the late stages of the polymerization, where 99% of monomers have been consumed.
The extent of the...
Modified-Release Drug Delivery Systems: Rate-Programmed II01:19

Modified-Release Drug Delivery Systems: Rate-Programmed II

Rate-programmed drug delivery systems release drugs in a controlled manner to maintain therapeutic levels. Three main designs include reservoir, matrix, and hybrid systems.Reservoir systems consist of a drug core enclosed within a membrane that controls drug release. In non-swelling reservoir systems, polymers like ethyl cellulose or polymethacrylates are used. These do not hydrate in aqueous media and control release through membrane thickness, porosity, or insolubility. This type includes...