Related Experiment Video
Updated: May 17, 2026

Unraveling Entropic Rate Acceleration Induced by Solvent Dynamics in Membrane Enzymes
Published on: January 16, 2016
Ion desolvation as a mechanism for kinetic isotope fractionation in aqueous systems
Amy E Hofmann1, Ian C Bourg, Donald J DePaolo
1Geochemistry Department, Earth Sciences Division, Lawrence Berkeley National Laboratory, Berkeley, CA 94720, USA. aehofmann@lbl.gov
Abstract:
Molecular dynamics simulations show that the desolvation rates of isotopes of Li(+), K(+), Rb(+), Ca(2+), Sr(2+), and Ba(2+) may have a relatively strong dependence on the metal cation mass. This inference is based on the observation that the exchange rate constant, k(wex), for water molecules in the first hydration shell follows an inverse power-law mass dependence (k(wex) ∝ m(-γ)), where the coefficient γ is 0.05 ± 0.01 on average for all cations studied. Simulated water-exchange rates increase with temperature and decrease with increasing isotopic mass for each element. The magnitude of the water-exchange rate is different for simulations run using different water models [i.e., extended simple point charge (SPC/E) vs. four-site transferrable intermolecular potential (TIP4P)]; however, the value of the mass exponent γ is the same. Reaction rate theory calculations predict mass exponents consistent with those determined via molecular dynamics simulations. The simulation-derived mass dependences imply that solids precipitating from aqueous solution under kinetically controlled conditions should be enriched in the light isotopes of the metal cations relative to the solutions, consistent with measured isotopic signatures in natural materials and laboratory experiments. Desolvation effects are large enough that they may be a primary determinant of the observed isotopic fractionation during precipitation.
More Related Videos
Related Concept Videos
Energetics of Solution Formation
When the strengths of the intermolecular forces of attraction between solute and solvent species in a solution are no different than those present in the separated components, the solution is formed with no accompanying energy change. Formation of the solution requires the solute–solute and solvent–solvent electrostatic forces to...
Intermolecular Forces in Solutions
When the strengths of the intermolecular forces of attraction between solute and solvent species in a solution are no different than those present in the separated components, the solution is formed with no accompanying energy change. Such a solution is called an ideal solution. A mixture of ideal gases (or gases such as helium and argon,...
Entropy and Solvation
Aqueous Solutions and Heats of Hydration
When ionic compounds dissolve in water, the ions in the solid separate and disperse uniformly throughout the solution because water molecules surround and solvate the ions, reducing the strong electrostatic forces between them. This process...
Solubility
A solution is a homogeneous mixture composed of a solvent, the major component, and a solute, the minor component. The physical state of a solution—solid, liquid, or gas—is typically the same as that of the solvent. Solute concentrations are often described with qualitative terms such as dilute (of relatively low concentration) and concentrated (of relatively high concentration).
In a solution, the solute particles (molecules, atoms, and/or ions)...
Theories of Dissolution: Diffusion Layer Model
This process starts with a thin layer, saturated with the drug, forming at the interface between the solid and liquid. The solute then diffuses from this layer into the main solution. The Noyes-Whitney equation suggests that the rate of dissolution relies on the diffusion...

