Related Experiment Video
Updated: May 16, 2026

Orientational Transition in a Liquid Crystal Triggered by the Thermodynamic Growth of Interfacial Wetting Sheets
Published on: May 15, 2017
Domain wall damping and elastic softening in SrTiO3: evidence for polar twin walls
J F Scott1, E K H Salje, M A Carpenter
1Department of Physics, University of Cambridge, Cambridge CB3 0HE, United Kingdom.
Abstract:
A marked change in anelastic properties, namely, elastic softening accompanied by increased damping, has been observed in a single crystal of SrTiO(3) below ~50 K by resonant ultrasound spectroscopy. This correlates with other subtle changes in structure and properties which have been explained in the past in terms of a novel quantum state and the formation of polar clusters in an incipient ferroelectric structure. Comparison of the new data, obtained at frequencies near 1 MHz, with mechanical spectroscopy data collected at a few Hz or a few kHz, reveals a distinct dispersion with frequency and is interpreted in terms of an acoustic loss mechanism which depends primarily on the mobility under stress of ferroelastic twin walls. In most ferroelastic materials, it is found that the twin walls become immobile below some low-temperature interval due to the pinning effects of defects. It is proposed instead for SrTiO(3) that associated with the local atomic displacements within the incipient ferroelectric clusters is a change in structure of the twin walls such that their mobility becomes enhanced. We propose that the structural change is not correlated with structural changes of the bulk material but relates to increasing polarity of the walls. This interpretation implies that ferroelastic domain walls in SrTiO(3) become ferroelectric at low temperatures.
More Related Videos
Related Concept Videos
Expansion and Contraction in Masonry Walls
To...
Theories of Dissolution: The Danckwerts' Model and Interfacial Barrier Model
Thin-Walled Hollow Shafts
Molecular Shape and Polarity
Posttensioned Masonry Walls
Post-tensioned masonry walls use high-strength steel rods or flexible tendons to enhance the strength and efficiency of masonry structures. These elements are securely anchored to the foundation and extend vertically either within the cores of the masonry units or between the masonry wythes. The construction process involves building the wall with these tensioning elements in place and allowing the mortar to fully cure.
Following the curing process, the tensioning begins. Steel rods are...
Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity

