[Homage to Professor Hans-Jürg Leisinger]

The direction in which the induced emf drives the current around a wire loop can be found through the negative sign. However, it is usually easier to determine this direction with Lenz's law, named in honor of its discoverer, Heinrich Lenz (1804–1865). Lenz's law states that the direction of the induced emf drives the current around a wire loop always to oppose the change in magnetic flux that causes the emf.
If a bar magnet is moved toward a coil such that the magnetic flux through the coil...

There are two ways to determine the amount of heat involved in a chemical change: measure it experimentally, or calculate it from other experimentally determined enthalpy changes. Some reactions are difficult, if not impossible, to investigate and make accurate measurements for experimentally. And even when a reaction is not hard to perform or measure, it is convenient to be able to determine the heat involved in a reaction without having to perform an experiment.

Kohlrausch's law explains that at infinite dilution, where dissociation is complete, each ion's contribution to the conductivity of the electrolyte is independent of the nature of other ions present in the solution. It also implies that when an electrolyte is highly diluted, the conductance of the electrolyte is the sum of the individual conductances of the ions it generates upon dissociation. The quantity of electricity an ion carries is proportional to its molar ionic conductance, which...

To determine the electron configuration for any particular atom, we can build the structures in the order of atomic numbers. Beginning with hydrogen, and continuing across the periods of the periodic table, we add one proton at a time to the nucleus and one electron to the proper subshell until we have described the electron configurations of all the elements. This procedure is called the aufbau principle, from the German word aufbau (“to build up”). Each added electron occupies the subshell of...

Chemical bonds are complex interactions between two or more atoms or ions, which reduce the potential energy of the molecule. Gilbert N. Lewis developed a model called the Lewis model that simplified the depiction of chemical bond formation and provided straightforward explanations for the chemical bonds seen in most common compounds.

In a Diels–Alder reaction, the diene is usually an electron-rich system and acts as a nucleophile, whereas the dienophile is electron-deficient and functions as an electrophile. Much like the diene, the nature of the dienophile significantly impacts the outcome of the reaction.
Characteristics of Dienophiles
Generally, the best dienophiles are alkenes containing electron-withdrawing substituents such as carbonyl, nitrile, and nitro groups. The feasibility of a Diels–Alder reaction depends on...