Related Experiment Video

Updated: May 13, 2026

Comparison of Kinetic Characteristics of Footwork during Stroke in Table Tennis: Cross-Step and Chasse Step
07:19

Comparison of Kinetic Characteristics of Footwork during Stroke in Table Tennis: Cross-Step and Chasse Step

Published on: June 16, 2021

Relationship between motor variability, accuracy, and ball speed in the tennis serve

Ruperto Menayo Antúnez1, Francisco Javier Moreno Hernández, Juan Pedro Fuentes García

  • 1Faculty of Physical Activity and Sport. San Antonio Catholic University Campus de Los Jerónimos, Guadalupe, Spain.

Journal of Human Kinetics
|March 15, 2013
PubMed

Keywords:
performancetennis servevariability

More Related Videos

Importance of Jumping Ability in Handball Throwing Speed and Accuracy02:43

Importance of Jumping Ability in Handball Throwing Speed and Accuracy

Published on: April 4, 2025

Methods to Explore the Influence of Top-down Visual Processes on Motor Behavior09:49

Methods to Explore the Influence of Top-down Visual Processes on Motor Behavior

Published on: April 16, 2014

Related Concept Videos

Force and Momentum01:17

Force and Momentum

Force and momentum are intimately related. Force acting over time can change momentum, and Newton's second law of motion can be stated in its most broadly applicable form in terms of momentum. Momentum can be applied to systems where the mass is changing, such as rockets, as well as to systems of constant mass. Also, momentum continues to be a key concept in the study of atomic and subatomic particles in quantum mechanics. One can consider systems with varying mass in some detail; however, the...
Motion of a Projectile01:23

Motion of a Projectile

Projectile motion becomes evident when a player kicks the ball into the air. The launch angle, or the angle at which the ball is kicked, plays a crucial role in determining the trajectory of the projectile. As the ball soars through the air, influenced solely by gravity, its motion can be dissected into two independent velocity components: the horizontal and the vertical.
Horizontal motion, governed by the initial kick, maintains a constant velocity throughout the flight of the soccer ball.
Relating Angular And Linear Quantities - I01:09

Relating Angular And Linear Quantities - I

If the rotational definitions are compared with the definitions of linear kinematic variables from motion along a straight line and motion in two and three dimensions, we can observe a mapping of the linear variables to the rotational ones.
When comparing the linear and rotational variables individually, the linear variable of position has physical units of meters, whereas the angular position variable has dimensionless units of radians, as it is the ratio of two lengths. The linear velocity...
Angular Velocity and Acceleration01:11

Angular Velocity and Acceleration

We previously discussed angular velocity for uniform circular motion, however not all motion is uniform. Envision an ice skater spinning with their arms outstretched; when they pull their arms inward, their angular velocity increases. Additionally, think about a computer's hard disk slowing to a halt as the angular velocity decreases. The faster the change in angular velocity, the greater the angular acceleration. The instantaneous angular acceleration is defined as the derivative of angular...
Variation01:19

Variation

An important characteristic of any set of data is the variation in the data. In some data sets, the data values are concentrated closely near the mean; in other data sets, the data values are more widely spread out from the mean. The most common measure of variation, or spread, is the standard deviation, which is the square root of variance.
When independent and dependent variables are plotted on a scatter plot, the slope of a line is a value that describes the rate of change between the two...
Relative Motion Analysis - Acceleration01:10

Relative Motion Analysis - Acceleration

A slider-crank mechanism converts rotational motion from the crank into linear motion of the slider or vice versa. This mechanism consists of three main parts: the crank, the connecting rod, and the slider. The movement of the slider-crank is an example of general plane motion as the fluctuating angle between the crank and the connecting rod. Consider a segment AB where point A is at the end of the slider and point B is on the diametrically opposite end to point A, on a crack. The variance in...