Related Experiment Video
Updated: May 12, 2026

A Protocol for Safe Lithiation Reactions Using Organolithium Reagents
Published on: November 12, 2016
Computed CH acidity of biaryl compounds and their deprotonative metalation by using a mixed lithium/zinc-TMP base
Raghu Ram Kadiyala1, David Tilly, Elisabeth Nagaradja
1Equipe Chimie et Photonique Moléculaires, Institut des Sciences Chimiques de Rennes, UMR 6226 CNRS-Université de Rennes 1, Bâtiment 10A, Case 1003, Campus Scientifique de Beaulieu, 35042 Rennes, France.
Abstract:
With the aim of synthesizing biaryl compounds, several aromatic iodides were prepared by the deprotonative metalation of methoxybenzenes, 3-substituted naphthalenes, isoquinoline, and methoxypyridines by using a mixed lithium/zinc-TMP (TMP=2,2,6,6-tetramethylpiperidino) base and subsequent iodolysis. The halides thus obtained, as well as commercial compounds, were cross-coupled under palladium catalysis (e.g., Suzuki coupling with 2,4-dimethoxy-5-pyrimidylboronic acid) to afford various representative biaryl compounds. Deprotometalation of the latter compounds was performed by using the lithium/zinc-TMP base and evaluated by subsequent iodolysis. The outcome of these reactions has been discussed in light of the CH acidities of these substrates, as determined in THF solution by using the DFT B3LYP method. Except for in the presence of decidedly lower pKa values, the regioselectivities of the deprotometalation reactions tend to be governed by nearby coordinating atoms rather than by site acidities. In particular, azine and diazine nitrogen atoms have been shown to be efficient in inducing the reactions with the lithium/zinc-TMP base at adjacent sites (e.g., by using 1-(2-methoxyphenyl)isoquinoline, 4-(2,5-dimethoxyphenyl)-3-methoxypyridine, or 5-(2,5-dimethoxyphenyl)-2,4-dimethoxypyrimidine as the substrate), a behavior that has already been observed upon treatment with lithium amides under kinetic conditions. Finally, the iodinated biaryl derivatives were involved in palladium-catalyzed reactions.
Related Concept Videos
Acidity of 1-Alkynes
The acidic strength of hydrocarbons follows the order: Alkynes > Alkenes > Alkanes. The strength of an acid is commonly expressed in units of pKa — the lower the pKa, the stronger the acid. Among the hydrocarbons, terminal alkynes have lower pKa values and are, therefore, more acidic. For example, the pKa values for ethane, ethene, and acetylene are 51, 44, and 25, respectively, as shown here.
Acid Halides to Ketones: Gilman Reagent
As shown below, the mechanism proceeds in two steps. First, one of the alkyl groups of the reagent acts as a nucleophile and attacks the acyl carbon of the acid chloride to form a tetrahedral intermediate. This is followed by the reformation of the carbon–oxygen double...
EDTA: Auxiliary Complexing Reagents
Basicity of Heterocyclic Aromatic Amines
Acid Halides to Carboxylic Acids: Hydrolysis
As shown below, the mechanism involves a nucleophilic attack by water at the carbonyl carbon to form a tetrahedral intermediate. This is followed by the reformation of the carbon–oxygen π bond along with the departure of a halide ion. A final proton transfer step yields carboxylic acid...
Extraction: Advanced Methods

