Related Experiment Video
Updated: May 10, 2026

Determining and Controlling External Power Output During Regular Handrim Wheelchair Propulsion
Published on: February 5, 2020
The effect of different inter-pad distances on the determination of active drag using the Measuring Active Drag
S Schreven1, H M Toussaint, J B J Smeets
1Research Institute MOVE, Faculty of Human Movement Sciences, VU University Amsterdam, The Netherlands. s.schreven@vu.nl
Abstract:
The Measuring Active Drag (MAD) system was developed to determine active drag in swimming by measuring the push-off force exerted at fixed pads placed below the waterline. The imposed inter-pad distance, which to date has been kept constant while using the MAD system, could affect the active drag because it requires the use of different stroke frequencies. The aim of the present study was therefore to determine the effect of inter-pad distance on active drag at a given speed. In particular, drag-velocity curves at three different inter-pad distances (1.25m, 1.35m and 1.45m) were determined using the MAD system for eleven competitive swimmers. Variation of 16% in inter-pad distance (14% change in stroke frequency) revealed no significant difference in calculated active drag between different inter-pad distances and a low (<5%) average coefficient of variation over different inter-pad distances was found. In addition, inter-test reliability, which was determined for the two 1.35m conditions only, was high (ICC>0.90) for measurements on two consecutive days. The results suggest that it may not be necessary to adapt the inter-pad distance of the MAD system based on anthropometric characteristics of the subject or the velocity-related stroke length in free swimming.
Related Concept Videos
Drag
Correlation of Experimental Data
For example, a spherical particle moving through a viscous fluid experiences drag. Dimensional analysis shows that the drag force depends on the particle's diameter, velocity, and...
Drag Force and Terminal Speed
Magnetic Damping
If, however, the bob is a slotted metal plate, the magnet produces a much smaller effect. When a slotted metal plate enters the field, an emf is induced by the change in flux; however, it is less effective because the slots limit the...

