Production of ethanol from sweet sorghum juice using VHG technology: a simulation case study

The aims of this study were to develop the kinetic model and determine kinetic parameters describing ethanol production from sweet sorghum juice using very high gravity technology in the batch fermentation of Saccharomyces cerevisiae NP01. The obtained experimental data were tested with four different types of model, based on the experimental data, accounting for the substrate limitation, substrate inhibition, product inhibition, and the combination of those three effects, respectively. The optimization technique to find kinetic parameters was non-linear regression using Marquardt method performed through numerical procedure. The chosen model with its kinetic parameters obtained in the batch mode was validated and tested against the other independent experimental data in the small batch-scale and large-scale fermenter, in order to investigate the applicability and scale-up effect of the model, respectively. Then, the obtained model with its parameters was applied in the simulations of the continuous and fed-batch operations to examine the concentration profiles of fermentation components with the variations in operating parameters such as the dilution rate, feed-flow rate, start-up time, and feed concentration. The results indicated that the kinetic model (the substrate limitation with substrate and product inhibition effects) was suitable to describe ethanol fermentation. In the continuous mode, using the dilution rate of 0.01 h(-1), the maximum ethanol concentration obtained was, approximately, 90 g/l whereas the simulated results from the fed-batch operation revealed that the maximum ethanol concentration at quasi-steady state condition was, approximately, 96 g/l. The start-up time of 21 h was the fastest time to reach the steady-state and quasi-steady state for both the continuous and fed-batch modes, respectively.