Related Experiment Video

Updated: May 9, 2026

In Situ Transmission Electron Microscopy with Biasing and Fabrication of Asymmetric Crossbars Based on Mixed-Phased a-VOx
09:49

In Situ Transmission Electron Microscopy with Biasing and Fabrication of Asymmetric Crossbars Based on Mixed-Phased a-VOx

Published on: May 13, 2020

Key concepts behind forming-free resistive switching incorporated with rectifying transport properties

Yao Shuai1, Xin Ou, Wenbo Luo

  • 1State Key Laboratory of Electronic Thin Films and Integrated Devices, University of Electronic Science and Technology of China, Chengdu 610054, China.

Scientific Reports
|July 18, 2013
PubMed

More Related Videos

A Method for Growing Bio-memristors from Slime Mold07:46

A Method for Growing Bio-memristors from Slime Mold

Published on: November 2, 2017

Effect of Bending on the Electrical Characteristics of Flexible Organic Single Crystal-based Field-effect Transistors08:43

Effect of Bending on the Electrical Characteristics of Flexible Organic Single Crystal-based Field-effect Transistors

Published on: November 7, 2016

Related Concept Videos

Bridge rectifier01:24

Bridge rectifier

The bridge rectifier is essential in electronics for efficiently converting alternating current (AC) to direct current (DC). Comprised of four diodes configured in a bridge layout, this rectifier effectively processes both the positive and negative halves of the AC waveform, making it superior to half-wave and full-wave center-tapped rectifiers in terms of voltage regulation and output stability.
Operationally, the bridge rectifier allows current flow through two of its diodes during each...
Characteristics of MOSFET01:17

Characteristics of MOSFET

Metal-oxide-semiconductor field-effect Transistors, or MOSFETs, play a critical role in electronic circuits. They are primarily utilized for amplifying and switching signals.
Various vital parameters influence their functionality, which is crucial for theory and electronics applications. First, channel dimensions, precisely length, and width, are pivotal. The size of these channels affects the transistor's ability to carry current and switching speeds; shorter channels typically enable quicker...
Ohm's Law01:19

Ohm's Law

Resistors are fundamental components in electrical circuits, often manufactured from metallic alloys or carbon compounds. They model a material's ability to resist the flow of electric current, a characteristic that is crucial in controlling and regulating electrical power within a circuit.
This current-resisting behavior of resistors is governed by Ohm's law, which states that the voltage across a resistor is directly proportional to the current flowing through it.
Ohm's Law01:21

Ohm's Law

Many materials exhibit a simple relationship between the values of current, voltage, and resistance, known as Ohm’s law. The current that flows through most substances is directly proportional to the voltage applied to them. The German physicist Georg Simon Ohm (1787–1854) was the first to demonstrate experimentally that the current in a metal wire is directly proportional to the voltage applied. Any material, component, or device that obeys Ohm’s law, where the current through the device is...
Switching of BJT01:22

Switching of BJT

Switching behavior in Bipolar Junction Transistors (BJTs) is a fundamental aspect utilized in various electronic circuits, particularly for digital logic applications like switches and amplifiers. In a typical switching circuit, a BJT alternates between cut-off and saturation modes, corresponding to the "off" and "on" states, respectively, thus behaving like an ideal switch.
Cut-off Mode ("Off" State): In this state, both the emitter-base and collector-base junctions are reverse-biased. The...
Electrical Transport01:29

Electrical Transport

The electrical transport property of a material is defined by its resistance and conductivity. Resistance is the measure of a material's ability to resist the flow of electric current, while conductivity gauges its ability to allow the current to pass through, depending on the geometry of the measurement cell, such as electrode spacing and area. Conductivity is measured in Siemens (S). There are different types of conductance, including specific conductance, equivalent conductance, and molar...