Validation of a standardised method for determining beryllium in human urine at nanogram level

The potential toxicity of beryllium at low levels of exposure means that a biological and/or air monitoring strategy may be required to monitor the exposure of subjects. The main objective of the work presented in this manuscript was to develop and validate a sensitive and reproducible method for determining levels of beryllium in human urine and to establish reference values in workers and in non-occupationally exposed people. A chelate of beryllium acetylacetonate formed from beryllium(II) in human urine was pre-concentrated on a SPE C18 cartridge and eluted with methanol. After drying the eluate, the residue was solubilised in nitric acid and analysed by atomic absorption spectrometry and/or inductively coupled plasma mass spectrometry. The proposed method is 4 to 100 times more sensitive than other methods currently in routine use. The new method was validated with the concordance correlation coefficient test for beryllium concentrations ranging from 10 to 100 ng/L. Creatinine concentration, urine pH, interfering compounds and freeze-thaw cycles were found to have only slight effects on the performance of the method (less than 6%). The effectiveness of the two analytical techniques was compared statistically with each other and to direct analysis techniques. Even with a detection limit of 0.6 ng/L (obtained with inductively coupled plasma mass spectrometry), the method is not sensitive enough to detect levels in non-occupationally exposed persons. The method performance does however appear to be suitable for monitoring worker exposure in some industrial settings and it could therefore be of use in biological monitoring strategies.