Related Experiment Video

Updated: May 7, 2026

Simulation of a Scaled Assembly Process with Collaboration of a Robotic Arm and Monitoring through a Vision System for Quality Control
05:47

Simulation of a Scaled Assembly Process with Collaboration of a Robotic Arm and Monitoring through a Vision System for Quality Control

Published on: August 29, 2025

686

Identifying single points of failure in your organisation

Robby J Bryant

    Journal of Business Continuity & Emergency Planning
    |October 12, 2013
    PubMed

    Keywords:
    external riskinternal riskorganisational riskrisk mitigationsingle point of failuresingle point of failure audit

    More Related Videos

    Detection of Targetable Alterations in Non-small Cell Lung Cancer using Next-generation Sequencing05:17

    Detection of Targetable Alterations in Non-small Cell Lung Cancer using Next-generation Sequencing

    Published on: October 10, 2025

    566

    Related Concept Videos

    Design Consideration01:22

    Design Consideration

    Designing a structure involves a series of considerations, primarily the material's ultimate strength, calculated through tests that measure changes under increased force until the material reaches its breaking point or limit. The ultimate load, where the material breaks, is divided by its original cross-sectional area, resulting in the ultimate normal stress or strength. The ultimate shearing stress is another significant factor taken into account.
    The factor of safety is another key...
    681
    Interpreting Run Charts01:25

    Interpreting Run Charts

    Run charts, essentially line graphs plotted over time, serve as fundamental yet effective tools for process analysis. They chronicle data sequentially, facilitating the identification of trends, shifts, or cyclical movements. This graphical representation is instrumental in determining whether a process is stable or exhibits signs of potential instability indicative of special cause variation. In the healthcare domain, run charts depict infection rates over time, enabling hospitals to monitor...
    3.2K
    Unsymmetric Loading of Thin-Walled Members01:23

    Unsymmetric Loading of Thin-Walled Members

    Thin-walled members with non-symmetrical cross-sections are vital to engineering structures, offering material efficiency and structural integrity. However, unsymmetrical loading on these members leads to complex stress distributions, resulting in simultaneous bending and twisting can cause deformation or structural failure. The interaction between bending and twisting requires detailed analysis to ensure structural resilience.
    The concept of the shear center is crucial in countering the...
    515
    Fatigue01:21

    Fatigue

    Fatigue occurs when materials rupture under repeated or fluctuating loads, even at stress levels far below their static breaking strength. It typically results in brittle failure, even for ductile materials. It is a critical consideration in designing machines and structural components subjected to repetitive or varying loads. The nature of these loadings can range from fluctuating loads like unbalanced pump impellers causing vibrations to repeatedly bending a thin steel rod wire back and forth...
    1.1K
    Quality Assurance01:19

    Quality Assurance

    Quality assurance is the overarching term used to describe the activities employed to ensure the proper performance of a system. These activities can be classified into three categories: quality control, quality assessment, and internal corrective measures. Typically, these activities work cyclically: quality control is performed before and during the analysis, while quality assessment occurs during and after the investigation. Internal corrective measures are implemented based on the findings...
    4.0K
    Zones of Protection01:16

    Zones of Protection

    In power systems, the entire setup is divided into protective zones to isolate faults and protect the rest of the network. These zones include generators, transformers, buses, transmission lines, distribution lines, and motors. Each zone can be visualized as a separate room in a house, with each room protected by its own circuit breaker.
    Protective zones are defined by closed dashed lines, containing one or more components. A key characteristic of these zones is the strategic placement of...
    996