Related Experiment Video

Updated: May 6, 2026

The Combination of Transcranial Alternating Current Stimulation and Electroencephalogram
06:14

The Combination of Transcranial Alternating Current Stimulation and Electroencephalogram

Published on: October 10, 2025

810

Mental contrasting and transfer of energization

A Timur Sevincer1, P Daniel Busatta, Gabriele Oettingen

  • 11University of Hamburg, Germany.

Personality & Social Psychology Bulletin
|October 23, 2013
PubMed

Keywords:
effortenergizationexpectationsmental contrastingperformance

More Related Videos

State-Dependency Effects on TMS: A Look at Motive Phosphene Behavior12:38

State-Dependency Effects on TMS: A Look at Motive Phosphene Behavior

Published on: December 28, 2010

9.9K
Dissociation of the Confounding Influences of Expectancy and Integrative Difficulty Residing in Anomalous Sentences in Event-related Potential Studies05:22

Dissociation of the Confounding Influences of Expectancy and Integrative Difficulty Residing in Anomalous Sentences in Event-related Potential Studies

Published on: May 9, 2019

4.7K

Related Concept Videos

Insensitive Nuclei Enhanced by Polarization Transfer (INEPT)01:15

Insensitive Nuclei Enhanced by Polarization Transfer (INEPT)

Insensitive Nuclei Enhanced by Polarization Transfer (INEPT) is an advanced Nuclear Magnetic Resonance (NMR) technique specifically designed to detect and enhance the signals of low-abundance nuclei, such as carbon-13 and nitrogen-15, in small molecules. The fundamental principle behind INEPT is the transfer of polarization from a more abundant and highly polarizable nucleus, typically hydrogen-1, to the low-abundance nucleus of interest. This process effectively boosts the NMR signal of the...
1.2K
Electric Potential Energy01:20

Electric Potential Energy

When an electric field accelerates a free positive charge q, it is given kinetic energy. The process is analogous to an object accelerated by a gravitational field as if the charge were going down an electrical hill where its electric potential energy is converted into kinetic energy. Of course, the sources of the forces are very different. The work done on a charge q by the electric field in this process helps to develop a definition of electric potential energy.
The electrostatic or Coulomb...
6.3K
Induction01:16

Induction

An emf is induced when the magnetic field in a coil is changed by pushing a bar magnet into or out of the coil. emfs of opposite signs are produced by motion in opposite directions, and the directions of emfs are also reversed by reversing poles. The same results are produced if the coil is moved rather than the magnet—it is the relative motion that is important. The faster the motion, the greater the emf. Additionally, there is no emf when the magnet is stationary relative to the coil.
4.9K
Motional Emf01:22

Motional Emf

Magnetic flux depends on three factors: the strength of the magnetic field, the area through which the field lines pass, and the field's orientation with respect to the surface area. If any of these quantities vary, a corresponding variation in magnetic flux occurs. If the area through which the magnetic field lines are passing changes, then the magnetic flux also changes. This change in the area can be of two types: the flux through the rectangular loop increases as it moves into the...
3.3K
Charging Conductors By Induction01:15

Charging Conductors By Induction

The Earth is a good conductor of electricity, and it is so big that it can be considered an infinite source or sink of charges. It can easily exchange charges with any matter.
Generally, conductors like metals do not allow any excess charge to be present on them. Any excess charge added to metals easily flows away, for example, when a metal is placed on the Earth. This process is called earthing.
However, conductors can be charged by a process called induction. For example, consider charging a...
7.8K
Energy In A Magnetic Field01:24

Energy In A Magnetic Field

If a magnetic field is sustained, there must be a current in a closed circuit or loop, implying some energy has been spent in creating the field. If this energy is not dissipated via the circuit's resistance, it is stored in the field.
Take an ideal inductor with zero resistance. Although it's practically impossible, assume that the coil's resistance is so small that it is practically negligible. The loss of the field's energy to dissipate thermal energy (or heat) is thus...
1.6K