Related Experiment Video

Updated: May 6, 2026

In vitro Enrichment of Ovarian Cancer Tumor-initiating Cells
11:37

In vitro Enrichment of Ovarian Cancer Tumor-initiating Cells

Published on: February 18, 2015

13.5K

Pioneer ACOs. And then there were 23

Peter Wehrwein

    Managed Care (Langhorne, Pa.)
    |October 30, 2013
    PubMed
    Abstract

    No abstract available in PubMed .

    More Related Videos

    Bringing the Visible Universe into Focus with Robo-AO10:35

    Bringing the Visible Universe into Focus with Robo-AO

    Published on: February 12, 2013

    21.4K
    Author Spotlight: Unraveling the Mysteries of Terrestrial Anaerobic Microorganisms in Uncharted Environments by In Situ Culturing07:56

    Author Spotlight: Unraveling the Mysteries of Terrestrial Anaerobic Microorganisms in Uncharted Environments by In Situ Culturing

    Published on: January 12, 2024

    1.7K

    Related Concept Videos

    Crossing over01:34

    Crossing over

    7.1K
    Crossing Over01:30

    Crossing Over

    Crossing over is the exchange of genetic information between homologous chromosomes during prophase I of meiosis I. Genetic recombination gives rise to allelic diversity in the newly formed daughter cells. In humans, crossing over produces genetically distinct haploid egg and sperm cells that undergo fertilization to produce unique offspring. Before cell division starts, the germ cell’s chromosome(s) undergo duplication in the S phase of the cell cycle. As the cells enter prophase I,...
    6.4K
    Crossing Over01:34

    Crossing Over

    Unlike mitosis, meiosis aims for genetic diversity in its creation of haploid gametes. Dividing germ cells first begin this process in prophase I, where each chromosome—replicated in S phase—is now composed of two sister chromatids (identical copies) joined centrally.
    The homologous pairs of sister chromosomes—one from the maternal and one from the paternal genome—then begin to align alongside each other lengthwise, matching corresponding DNA positions in a process...
    128.9K
    Pilot and Numeric Relaying01:21

    Pilot and Numeric Relaying

    Pilot relaying is a type of differential protection used in power systems. It compares electrical quantities at the terminals of equipment via a communication channel instead of direct relay interconnection. This method is essential for transmission lines where the terminals are far apart, typically up to 80 km for lines with 69 to 115 kV ratings. Four types of communication channels are used for pilot relaying:
    590
    Rab Cascades01:25

    Rab Cascades

    Rab GTPases act in a regulated cascade during membrane fusion, helping the lipid bilayers mix. The Rab family of proteins are active when bound to GTP, and inactive when bound to GDP. Hence, they act as guanine nucleotide-dependent molecular switches. Rab-GTP recognizes and binds to long or short-range tethering proteins to capture the target vesicle. These tethers coordinate with SNAREs on the vesicle and the target membrane to assemble the trans SNARE complex that locks the mixing bilayers.
    2.9K
    AC Sources01:20

    AC Sources

    Direct current is a flow of electric charge in only one direction and has a steady state of constant voltage in the circuit. Rectifiers, batteries, commutator-equipped generators, and fuel cells are some examples of devices that generate direct current. Nowadays, most applications use a time-varying voltage source. Alternating current is a flow of electric charge that periodically reverses direction. An alternating current is produced by an alternating emf that is generated in a power plant. If...
    3.5K