Condensation and freezing of droplets on superhydrophobic surfaces

Linda Oberli1, Dean Caruso2, Colin Hall2

  • 1Surface Science and Technology, ETH, Zurich, Wolfgang-Pauli-Str. 10, 8093 Zurich, Switzerland; Thin Film Coatings Group, Mawson Institute, University of South Australia, Mawson Lakes, SA 5095, Australia.

Related Concept Videos

States of Water01:23

States of Water

Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
46.6K
Cohesion01:07

Cohesion

Cohesion is the attraction between molecules of the same type, such as water molecules. Water molecules have an overall neutral charge but are polar molecule. An oxygen atom in one water molecule has a partial negative charge that can bind to a hydrogen atom with a partial positive charge in a second water molecule, forming a hydrogen bond. Each water molecule can form up to four hydrogen bonds with other water molecules. Hydrogen bonds are responsible for water's cohesive nature.
On a...
44.9K
Phase Transitions: Vaporization and Condensation02:39

Phase Transitions: Vaporization and Condensation

The physical form of a substance changes on changing its temperature. For example, raising the temperature of a liquid causes the liquid to vaporize (convert into vapor). The process is called vaporization—a surface phenomenon. Vaporization occurs when the thermal motion of the molecules overcome the intermolecular forces, and the molecules (at the surface) escape into the gaseous state. When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase...
17.0K
Sublimation01:03

Sublimation

Sublimation is the direct transformation of a solid to a gaseous state. For instance, at standard pressure and room temperature, solid carbon dioxide sublimes to gaseous carbon dioxide. The phase diagram depicts the conditions required for sublimation. This process occurs at the solid-gas phase boundary and is not observed above the triple point of the substance. The reverse of sublimation is called deposition, where a gaseous substance condenses directly into a solid. Sublimation and...
4.4K
Surface Tension, Capillary Action, and Viscosity02:57

Surface Tension, Capillary Action, and Viscosity

Surface Tension
The various IMFs between identical molecules of a substance are examples of cohesive forces. The molecules within a liquid are surrounded by other molecules and are attracted equally in all directions by the cohesive forces within the liquid. However, the molecules on the surface of a liquid are attracted only by about one-half as many molecules. Because of the unbalanced molecular attractions on the surface molecules, liquids contract to form a shape that minimizes the number...
28.7K
Colloidal precipitates01:09

Colloidal precipitates

The high insolubility of some precipitates can result in an unfavorable relative supersaturation. This can lead to colloidal particles with a large surface-to-mass ratio, where adsorption is promoted. For instance, in the precipitation of silver chloride, silver ions are adsorbed on the surface of the colloidal particles, forming a primary layer. This layer attracts ions of opposite charge (such as nitrate ions), forming a diffuse secondary layer of adsorbed ions. This electric double layer...
5.7K