Gene expression can be regulated at almost every step from gene to protein. Transcription is the step that is most commonly regulated. This involves the binding of proteins to short regulatory sequences on the DNA. This association can either promote or inhibit the transcription of a gene associated with the respective sequence.
Transcription results in the generation of precursor (pre-mRNA) that consists of both exons and introns, which needs further processing before being translated to a...

The gene expression in cells is regulated at different stages: (i) transcription, (ii) RNA processing, (iii) RNA localization, and (iv) translation. Transcriptional regulation is mediated by regulatory proteins such as transcription factors, activators, or repressors—these control gene expression by initiating or inhibiting the transcription of genes. Once a precursor or pre-mRNA is produced, it undergoes post-transcriptional modification, including 5' capping, splicing, and the...

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller...

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress...

A solute is a component of a solution that is typically present at a much lower concentration than the solvent. Solute concentrations are often described with qualitative terms such as dilute (of relatively low concentration) and concentrated (of relatively high concentration).
Concentrations may be quantitatively assessed using a wide variety of measurement units, each convenient for particular applications. Molarity (M) is a useful concentration unit for many applications in chemistry.